Recent content by SSELLARS

I will definately check it out. Thank you so much for the advice jarvis24x7. I will forward this information to my student and also my technical staff. Again thanks! ssellars

Yes you have to create a client for the virtual node. To configure a NetWorker cluster client: 1) Install NetWorker client package on all physical nodes. 2)Create a NetWorker client for each physical and virtual node. 3)Configure the save set attribute for each client. 4)Edit the remote access...

I teach Legato and have used many other products over the years. Legato is not bad. I have used much worse products. I think Legato is easy and works well. However, it is true that you need to set it up correctly from the start to avoid the nightmares you have heard of. But it is the same...

There are pre and post script possiblities with Legato. There is a special command called savepnpc. It allows for both pre and post processing. See the command page on its use. It runs the pre and post commands one time with a save in between. You apply the savepnpc in the client resource...

Have a student who has six drives in library idle, but when he clones his volumes manually he can only get one volume to clone at a time. The others queue up. I called Legato and was told that is how NetWorker is set up. But I find it hard to believe. Is there anyone who has had multiple...

Well this is not a perfect solution but.. you can write a directive to skip all the other extensions(hope there are not too many) and then only the .cgm files will get backed up. Look up UASM in command book and see skip.

I teach NetWorker Admin I and Advanced courses and even folks who have been working on Legato for over a year seem to get a lot out of my courses. The 6.x courses are a lot better than the 5.x classes were. I'm getting very positive feedback about the 6.x courses and how they have helped my...