Recent content by Sreelu

I am trying to install, RHEL4 WS. on my desktop computer. While in the installation, it does not recognize the harddrive [seems the kernel is not recognizing the SATA Harddrive]. Question: 1. Is there a way to point the SATA Harddisk drivers in the installation. 2. was wondering if there is a...

OK Got it... I See some CPU Overhead/Usage being increased. Hmmm... can it be handled ? Thanks Sree

ye yes...... I could see them. Thanks.. :) And in this scenario if i have to enable Shaping for a couple of IP's. Please Advice a effeciant way if exists. Sree

Hey It works Great. Thanks.. Man I have to do this for almost 16 ip's. I find that this increases the Router overhead. Please suggest if there are better and advanced way's to setup this. Thanks A Lot. Sree

I had Just tried, Negative. Bandwidth Not being shaped. I had disabled CEF also. Do u think any other factors influence this ? Let me if your want any other parts of the configuration. Thanks Sree

I think this will help in all ways. Please Find the Conf For Detailed Info: ________________________________________ ! ! interface Ethernet0/0 ip address y.y.y.153 255.255.255.240 secondary ip address x.x.x.1 255.255.255.240 ip access-group 101 in no ip redirects no ip unreachables no ip...

Thanks, I had Done the Same Actually. Still Not getting shaped[controlled]. Plese let me if you need any more details which would help you to suggest more in details. Thanks. Sree

Hi, I need to limit the bandwidth for some of the IP's leaving my 2600 e0/0. Setup : [Internet]---[S0/0 -- 2600 -- e0/0]---- [Public IP i want to limit traffic] Any Detailed Advice in appriciated. Thanks in Advance Sree

You need not to validate also you can skip that part of the check in the site and download and get it installed. But would still recomand a gateway level solution or Enterprise Edtion kind of solution for a network as it give a flexibility for centralized management. Thanks :)

hi Stu, hmmmmmm, this is a ISP. And i dont think that i can really check all my hundre's of pc's. but still as far as i had done. i am finding this problem only in one part of my network. i.e. only in two city's. And I had Update that network already with this fixes...

HI Our Network is effected with Code Red Worm, and I had applied the MS patch for my IIS also. Still the ARP table in my Cisco 2600 is flooded with wrong entries, after some time the Router start to Denny the services (DOS). ( it’s clear that I had been effected with Code Red Worm) I had been...

HI, Try Using a Tool Visula Route, Or Go for search in Google For NetGeo Tools. But Here also.. what Our Friend was telling is correct. May be u will get the nearest... GateWay or the Router. of that IP Pool. Pinpointing the Location is I am not sure....

how to configure or use the QOS, can u explain in breif. i am waiting here.... best regards

I want to Control the bandwith going through each port in my catalyst 2924, i am not confident whether it is possible or not. IF possible, reaply what information is required, i will post immediately. Thanks in advance.. for u'r help

An Article from the Microsoft Knowledge Base.. may Help u http://support.microsoft.com/?kbid=281485 Have a nice day. Srihari Maddula