Recent content by Spookytooth

You may be SOL. We tried it on two 6.3 systems recently and it failed. Avaya will not work on it and there is no v3 of the utility coming. The only user info we were able to get was from running pcap on sm100. We let it run for a while and eventually we got most of the users recorded by using...

Hello folks, Does any one know how to export the CM patch from the active server? We are rebuilding the standby server and the patch the cust. provided for the rebuild seems to be corrupt? We are looking to extract this particular patch- "03.0.124.0-21591.tar ". Even better if anyone has and...

Hello folks, I have a MM 5.2 w/ MSS. The unattended backup to the customers FTP server is not running at 3 AM. There are no alarms on the system when it doesn't run. I can do a manual backup to the FTP server with no issues. Anyone ever run into this before? Thanks in advance Cheers

Hello folks, I have an issue after migrating a customer from MM 3.1 w/ Qsig to MM 5.2 w/ SIP. On the 3.1 system the customer had several extensions set up with autodial buttons to check a general mailbox. The string is as follows - (vm hunt group)5000~p~p*#5555(mailbox) The 5.2 is ignoring...

One of the four is a PRI which was the sync source in the old system. It doesn't show up either. If I look in the old Definity we just cut from all 4 DS1's were listed as 'CIRCUIT PACKS AVAILABLE FOR SYNCRONIZATION' on the 'change sync' form.

Thanks 1a, tried setting them to 'y' already. Doesn't make a diff

Hello folks, we just put in an S8510 and our having a problem setting sync for the PN. We have 4 live DS1's in the PN. When we type 'change sync port 1' there are no DS1's listed as available for use as the sync source. We tried adding the primary and secondary sources but received a message...

Hello all, anyone ever install a BUPS on a G700? I was wondering if a P330 BUPS would work. Thanks

Hello all, anyone have any luck setting up SIP trunks on 4.0 without the SES server. Thanks

threw another medpro in and it comes up the same way. i'm wondering if this is something specific to s8400

hello all! i'm having a weird medpro issue where i am intermittently getting a no audio condition. there's no alarms against the board and the network seems fine. when i do a 'status media-processor' this is what i get Board Loc Code Vintage 01A14 TN2302AP HW18 FW115 Ethernet Enabled? yes Node...

try logging into the ipsi and doing a 'show qos' command. if 'vlan tagging' is turned on try turning it off

Hello all, I have an upgrade from 2.2 to 4 and would like to push the upgrade out over the customers network without having to get cd's out to all the sites. I have done this before for dot release upgrades say 2.2 to 2.2.2 by using ftp. Has anyone done something similar to this while going to...

Hello all, was wondering if anyone's seen this issue before. I have a G700 remotely connected to an 8700. The G700 has a local wink start t with a block of DID. The t is set up to insert the digit 9 and send all the DID's to the ars digit conversion table. One out of 20 calls or so are failing...

I spoke to Tier 4 yesterday, they confirmed it's working as designed and there is no workaround to avoid MM pulling the calls back. In QSIG all transfers are handled the same way regardless of whether we select Blind or Full on the MM. The call is pulled back after 6 Rings by MM and a...