Recent content by speedingwolf

Hi Andreh, Thanks for your time responding back to my post. About 2 years ago, i was able to restore exchange 2000 with this method in the lab with ArcServ11. I've done a few Exch 5.5 restored before and it was not as PITA as it is with AD. I think the BSOD system state restore threw me off in...

Umbletech, thanks for your respond. The restore job does not even put the IS onto the test restore exchange server. It failed after 3 minutes and reported the above error. 0 byte!

Greetings, I'm trying to simulate a total AD and Exchange disaster recovery using vmware, symantec ghost, and Veritas 10d Windows Server Backup and unable to restore exchange IS. Using Vmware, i promoted a win03 server as a DC in our environment. Then I took the vmware in a lab and seized its...

Hi, Have you looked into using open source software (ethereal) to do packet capture? or network tap hardware device for this solution?

Hi Bond, let me give a shot here. Look in the PIX config if it has something like: Allowing telnet from internal net inside to the pix. No restriction. telnet 192.168.101.0 255.255.255.0 inside telnet timeout 30 Allowing ssh from outside public IP address ssh 24.130.x.x 255.255.255.255...

On my network, certain servers don't have default gateway. No access to internet.

My .02 cents. Check on the PIX CPU counters

I'd like to update what's going since this post. I got the tunnel up, got both networks talked to each other but with one additional PIX. Originally, I want one PIX to do L2l and VPNClient. The tunnel work, but there is no routing between networks. I could not seem to figure it out so I used...

Thanks for your respond lashboy and sorry for the delay in responding. The PIX515E has version 7.1.1. According to Cisco, sysopt connection permit-ipsec is enable by default. Now I have another problem. I can see the tunnel but I can't access any resources both on each side: ping or anything...

Greetings all: I've configured cisco VPN tunnel before between PIX506 and VPN concentrator without any problem. I've configured Cisco VPN client to terminate at our HQ PIX516E without any problem. But now I am having problem creating a site to site tunnel between a PIX501 to a PIX515E. For the...

Thanks for responding Lloyd. I have a different pix with 6.3.4 and domain is called password and I can connect to internal machine via IP addresss. I just used the default from Cisco doc. In my opinion, I don't think it should not matter because I try to connect to the server using its IP...

Greetings all, I'm trying to vpn into the corpnet using the Cisco Client version 4.x. I can establish a tunnel; however, I can't seem to access any inside machine. Please point some lights. Here is the config. I have a feeling it is access-list issues or outbound restriction. Thanks PIX...

Hi all, We have an exchange 2003 configured as POP3 email. One of the execs has the Kyocera phone. The previous system admin configured the phone to receive email. It works fine. Now, the exec would like to reply and send email as if he is using Outlook. When he tries to reply to an email, it...

Hi Norton, Thanks for the information.

Greetings, Is it possible to have email deliver to the following format on an exchange server? 1. FirstnameLastname@company.com 2. Firstname.Lastname@company.com The big boss just came in and told us we need to have both alias for each user. I added and additional smtp to the email account...