Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
speed0920's latest activity
-
"In the SA configuration, we set up call resonance for extension 969 like this: ADD-SA:VCE,969,,,0,366,PRL,0,"...
-
“In the 4000 SA Hunt Group, where can I change the number of rings before it switches to the next extension? Right now it takes 8 rings...
-
Hey there! I just added an SIUX3 card, and it's now showing a green light. 10 Q2287-X SIUX3 2 0 Q2287-X 1 -05 - READY...
-
The system is 4000 V11. For the analog trunk format, my test on X8 shows DTMF. When adjusting the 4000 system to ETSI DTMF, it had no...
-
speed0920 replied to the thread Requesting support for STMIX."I just updated STMIX to the latest version, but the problem is still the same. Looks like this is going to be a hassle. Could this be...
-
-
speed0920 replied to the thread Requesting support for STMIX.I tested it, but I can't access sdat3—I can only get into sdat2. Is there a command to check if stmix is running properly?"
-
-
speed0920 replied to the thread Requesting support for STMIX.Alright, thanks! I'll give it another try tomorrow
-
speed0920 replied to the thread Requesting support for STMIX."I know it's a Linux system. Based on my past experience, it should work after installation and setting up the IP, allowing access via...
-
speed0920 replied to the thread Requesting support for STMIX.I haven't tested this yet. I'm not familiar with SSH commands, but I'll give it a try. I haven't tested this yet. I'm not familiar with...
-
speed0920 replied to the thread Requesting support for STMIX."I’ve already unlocked the lock symbol, but the issue is still the same. At first, I thought my system wasn’t installed properly, so I...
-
speed0920 replied to the thread Requesting support for STMIX.From what I remember, in V8, once BFDAT, BCSU, and CGWB were set up, HTTPS access was available right away. In V11, I currently have...
