Recent content by spamfree

Bingo! That's exactly the problem. Each time I ran the script interactively I was in the same directory as the file I was trying to size. That's why it ran from the command line, but not by cron. Well deserved star. Cheers.

It prints 14520 Which is the same as you get when you do: ls -l Thanks

Hi, I want to copy a file to the web directory if it's greater than a certain size. The file size is always > 15K The following runs without any errors, but fails to copy the file in question. ------------------------------------------------------------ file_size =...

Hi, you normally nead to load a MIB (management information base) file into HPOV. The MIB file is device specific to the MD110 in this case. You should be able to get this from your maintainer. Regards

Hi, Has anyone tested what features you get between Nortel Meridian and MD110 on QSig. We got basic call setup and number display. If you got more, configs would be appreciated. Thanks

We have sites with MD110s networked together via QSig on VoIP using Cisco 2611 routers with NM-HDV cards. All run software Version 12.2(11)T10. We get all required features. When we tried the new Cisco 2800 (12.3) we cannot get any features working. i.e 2800 to 2611s. Has anyone had similar...

You can get Erlang values for a route via the TR commands. If you are looking for CDR information you will need to have this set up via a SIU card or on the NIU card. This can then be logged. Connectios is through V24 interface. Cheers

Try. http://www.filesland.com/software/serial-port-logging.html or http://www.handyarchive.com/free/serial-port You can also use ttywatch if you are using any *nix. Good Luck.

Glad to see you got a solution. I automatically get a new logfile each day with the following 2 perl scripts. The file is named with the date of the day e.g. 2004-06-24.log Must have a user called 'cdr' with home directory '/home/cdr/' Hope this is some use to you. log.pl...

Windows and Unix do some things slightly different. As far as ttywatch is concerned it is logging binary data. If you look at the file with en editor you will see a load of non printing characters. Also if you use less filename. you will see these characters, but not with cat filname What you...

If you get an old PC and wipe the disk. Load linux on it. There's a small program called 'ttywatch' that logs from the serial port. Simple to configure. It can log a file for each day automatically. Put the PC on the LAN and you have ftp access to the logs. It's not as much trouble as it sounds.

I have found that the alapi command does not always output alarms (some CLASS 4) in BC9. All alarm classes are set for output. Yet when you print allip the alarm is there. alhbi & alapi are not commands that many people use so it doesn't surprise me that these faults have gone unnoticed for so long.

Have a look at http://www.ltsp.org/ And ther FAQ page as well. http://204.182.52.180/fom-serve/cache/1.html Regards Mike.

Hi, The remote access modems we use, DataTracker2700, also support SNMP forwarding of Alarms from the MD110 to a NMS. Has anyone used this function of the DataTracker? We're just in the initial stages of the project, but it looks very promising so far. Cheers

Hi, Has anyone seen, tested or implemented the EEBG from Ericsson. If so, how have you found its performance? Any high or low points that stand out? Thanks