Recent content by smoyer90

I just purchased 4506-E my old 6500 has catOS. how can I convert this command to IOS? Thanks-Steven set vtp domain xxxxxx set vtp mode transparent set vlan 1 name default type ethernet mtu 1500 said 100001 state active set vlan xxx name xxxxx type ethernet mtu 1500 said 100507 state active...

3750s may be the ticket! Thanks

Due to the fact Cisco EOL of the 6500 series. our company will be looking to replace the eight 6509 we are currently using. honestly we could use something that will take up less rack space. any suggestions?

We have Solarwinds....Thanks!

Is there a way to find out how many ports are being utilized in a WAN environment? We have a total of 900 Cisco switches across our campus. is there a way to generate a report is to how many switch ports are being used? without visiting every building in our WAN? we have 2960,3750,3560 and...

My boss wants to replace all of our cisco AP's and go with a lightweight system with a controller has anybody use the controller if so how hard is it to learn? I understand it would be a lot easier to configure one controller then to configure 40 AP's one at a time.

How can I setup etherchannel on two Cisco switches (1)WS-C3750G-48TS-S and (1)WS-C3750G-12S-S does anyone have a sample config I can use? Thanks

I was able to fix my problem by using. (config)#ip access-list standard 1 (config-std-nacl)#no permit host 192.168.x.x I guess with enough time and a Catalyst 2950 Series anything is possible. Thanks for all the great info.

Thanks for the info....

How to remove one acl statement without removing the whole string of acl. when I do a no access-list 1 permit 192.168.x.x it takes out all of my list.

Thanks oggywan, we are using Symantec AntiVirus Corporate Edition 10.0. I wasn't aware there was another version. Thanks

We have recently upgrade our Anti Virus software to SAV ver.10.0.0.359 some of our Win2K/sp4 clients are receving the following error "Rtvscan.exe has generated errors and will be closed by Windows. you need to restart the program. An error log is being created" Does anyone have suggestions to...

Thanks for the info us2001irvine.

I have the same problem and I get the "IRQ_NOT_LESS_OR_EQUAL" error. And I boot to safe mode and it works for about a week or two, then the error comes back. This is happening to all my new IBM machines I have on my network. I should have stayed with SAV version 9.

How right you are. I am currently using the same printer with Neoware boxes and they work great. and I have 20 thin clients installed and have another 20 to install. having a printer that works make my job a lot easier. Thanks!