Recent content by smithware

I need to use a monitoring tool to check for the existence of a handful of processes on an HP UX (11i?) box. The software can log on via SSH and run a script - STDOut should be in the form of: [SUCCESS|ERROR|UNCERTAIN]: {explanation} {DATA:<value>} and I need to check that ALL of these...

Hey All.... I have a Uniwell TX-870-03 touch screen POS terminal that was unplugged for a time and now says: IR DONE SETUP REQUIRED on the screen now. No combination of buttons nor key positions seems to allow me to do anything... Any hints on anything I can do? Can I upload the...

I don't think it is the flags, as the software hasn't changed a bit... I use the same system flags for all 4 registers (except for printing settings) and one of the registers is still working. I received a new register and was trying to create my own cable by mapping one of the other ones. I...

Hey all, weird problem... I have a 4 unit Uniwell POS (please consider both acronyms appropriate). I was adding a cash drawer to the only register without one and needed to duplicate the cable, so I unplugged a working one to trace the pins. That cash drawer stopped opening, even though in...

Hey All..... Just had an electra elite IPK system installed here with a 4 port 25 VMS card. It seems to be working fine... just a few small issues - We have the SPE card and I've been trying to get IP access to voicemail set up to no avail, but that's not my problem today - The installer...

Would restoring from an old backup do the trick? The system was originally set up as 770 being VM.

Well, that answers 1/2 my question, thank you. I am able to access the system with WinSPM (only using standard SPM mode though). How do I do the procedure you outlined (set up (in Legend programming) a Voice Mail calling group which contains at least the first voice mail port of the module (or...

I have a Merlin Legend System. We just replaced this system with another, now this is on my office floor and I'd like to strip the last of the voicemail off of it. I have the system itself up and running (I can make calls if I put a CO line in, but the VM never came back up.

Hey All, I have a Merlin Messaging card (1.0) in port 8 of my phone system. It's currently in standby mode and not answering calls. I only need to be able to get messages off of the card and written down, it is not a live system. Is there anyway to do this? I am not very knowledgeable about...