Recent content by SMC1

Did you Change the SNMP user name and Password. I found that this will cause these issue.

rstew3; I have run into this aswell. Installing wireless ITG does this a ton. Run a ethernet sniffer on the ehternet link. What you should find is the tx and rx packets shuold be the same codec. The phones might be using a defferant codec than the PBX. You can try tweeking the zones in...

My 2 cents I have a simular situation, I have an office a mile down the road. I found the most cost effective way to give them 13 phones with their current extensions was the I2004. They do cost about the same as a digital phone. As for the ISM it was aroung 80$ per phone. QoS I am running a...

Yes, the LTER promt in the route list. ( Local Termination )

The reply with the fcas is correct. If the 14 digit code is entered on the pbx side what it does is change the NCOS of the user for that call. So you will need to set up the routes the same as if you had multiple NCOS on phones. Build an FCAS to alow only the NXX you want in a NPA, Asign it...

If you are running meridian mail, check the restrictions in the mail. I have seen hackers use a person who is on vaction's mail box to threw dial out.

if you are familiar with procom, you can set up a script to input FCAS tables. you will need a FCAS to deny only 555 for each NPA a FCAS to alow only 555 for each NPA Next you will to modifiy your RLI's, one entre will have fcas for the deny and a duplicate entre that will alow only 555 and...

If you look at you group privilages you should be able to alow yourself to scheduale these updates from the client. You can ether set an automatic updates for a certain time of day or you have to send the update each time you chg anything

If you are running rls 25.15 the I2050 will not run. I had to upgrade to 25.40 to even get my SMC 3.0 card to work.

It depends on what system. Opt 61c - 81c that is the only way to buy your packages. I have to pay $1000 for my transaction fees. My advice is look at what packages you will need and buy them all at once. I have been getting my packages for about $200 a piece, However my maintenance contract...

You will need to contact a vender. I had the same issue with rls 24.24. I had to reload software on a new system ( it had no database yet) and the other I had a TAC Engineer load some patches in. These ACD's were part of the default database.

The problem with telnet is; Telnet is an IBM/DOS terminal emulation, The Opt 11c - 81c use an Operating system call VxWorks witch is a Unix based operating system. Rlogin is to Unix like Telnet is to Windows. Even when you get Rlogin you still need to have a VxWorks Id to get past the...

I have tried the telnet/rlogin on opt 11c's. Draw back is when you AX to voice mail you cannot ctl ] back out. If you do AX to voice mail with rlogin you will have to INI to get MM to release.