Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Skymander
-
Trouble configuring new T1 for WAN
We do not have this plugged into the T1 interface though. It is plugged into a serial port that goes through a CSU/DSU modem which appears to be working well. -
Trouble configuring new T1 for WAN
I just verified that esf and b8zs is correct -
Trouble configuring new T1 for WAN
Yes, I do have a T1 contoller interface (2 actually) but not for 0/2/0. controller T1 0/0/0 framing esf linecode b8zs channel-group 1 timeslots 1-8 controller T1 0/0/1 framing esf linecode b8zs channel-group 1 timeslots 1-8 Is this our problem? And how do we fix it? -
Trouble configuring new T1 for WAN
Anyone see any mistakes I made in the configuration? -
Trouble configuring new T1 for WAN
Here is the interface status on the remote router: Serial0/2/0 is up, line protocol is down Hardware is GT96K Serial Description: Main Lot New Internet address is 192.168.11.2/30 MTU 1500 bytes, BW 512 Kbit, DLY 20000 usec, reliability 255/255, txload 1/255, rxload 1/255... -
Trouble configuring new T1 for WAN
Here is the debug log for the main router: debug serial interface Serial network interface debugging is on *Feb 24 21:07:14.760: Serial0/3/1: attempting to restart *Feb 24 21:07:14.760: gt96k_mbrd_serial_mode_reg_init:: was DTE, now set to DTE *Feb 24 21:07:14.760: DTE idb->dte_interface =... -
Trouble configuring new T1 for WAN
Thanks for the reply David. This is an integrated T1 with 8 (0-7) channels dedicated to data. I believe PPP is the correct encapsulation. It is the same we use for another wan connection to a different remote location. Both T1s go direct (not point to point or frame relay). Here is the... -
Trouble configuring new T1 for WAN
Hi all, I am more of a software engineer than a networking guy but I dabble enough in routing to get the job done (normally) for minor things. Recently we moved to a new T1 at a remote office and I figured it would be easy to copy the config to a new interface and everything would work - not so...
