Recent content by silvercas

I have an Avaya definity with 0 SIP trunks. CM version is 5. What is the pricing for SIP trunks and how are these licenses normally installed

so i could probably get away with using a dialogic media gateway to my digital lines and satisfy the sip trunk requirements?

i agree. its a product that we are familiar with

We are looking at a callxpress voicemail system. Below is the integration guide. From looking at our licenses I know we already dont have SIP trunks as it is listed as 0. Also I believe we are on an Avaya software load of 5 as I see this in the web interface, install one of the follow...

below is the document the company wrote up. We dont current have any licenses for sip trunking. avaya cant give me a straight answer on cost for sip trunking licenses...

awesome Ill give it a try you seem to know about sip, have you worked with a callxpress vm system?

ok so change media-gateway 1 is the remote gateway. we have the 1T+2Tel" in v7. unfortunately we only have one page

We actually have a g350 in that location. the analog ports have to be configured???

Hello, We have a definity system. We have remote offices that use the Avaya 46xx series IP phones. Is there an avaya part that will allow an ip phone to analog converter? I would like to hookup a fax machine, etc. Thanks

We have an avaya definity system. How do I tell if we have Avaya Communications Manager SIP Station protocol ? I reached out to Avaya and got the run around.

danparrish we use 9 for outside line. so digit 9 min 6 max 24 and route pattern?

Hello, Within Avaya Site Manager, ARS Analysis table (list ars analysis location 1) we have some entries I believe are no longer needed. For instance we have entries for digits 3,4,5 for min and max digits of 7 going out route path 4 hnpa. If Im not mistaken I believe these were needed...

right now I cannot access the system via the network. I have to physically go to the machine

i have worked with legends before. how do I check the asa?

Hello, Since we lost power from hurricane sandy we are unable to access the s8700 via the network. if I connect a switch and assign ips on both ends, we are still unable to connect. Could the network card be in a down status on the s8700? Next I try to administer the s8700 through SAT...