Recent content by sikek

Hi can I please get some help for configuring dhcp-helper address on a extreme switch thank you . Do I only need to add this command ? config bootprelay add <ipaddress>

Hi i have two active routes in OSPF area 0 with the same equal cost. how can i make it select the 2nd router over the 1st ? do i have to adjust the cost on both sides ? show ip route 10.10.23.1 Routing entry for 10.10.23.0/24 Known via "ospf 1", distance 110, metric 2, type intra area Last...

thanks everyone i checked all the connecting devices interfaces for duplex and speed anything match can't found any errors when we do an iperf here's what we get im thinking it's a windowing issue . MY COMPUTER <—————AVG 3 Mbit/s————— > 192.168.1.10 (Fileserver) MY COMPUTER <—————AVG 3...

First off thanks for the replies . The issue has to deal with transfer of files so SMB shares/ftp/scp/sftp all run slow across this link it's connect to a cisco 3750. Here's the interface information from both devices. 2950 show interfaces gigabitEthernet 0/2 GigabitEthernet0/2 is up, line...

Hi any ideas on what could be causing the slow speed issue ? I check the output of the show interfaces port-channel 1 command. and i don't see anything wrong . MTU 1500 bytes, BW 2000000 Kbit, DLY 10 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not...

No i haven't tried rebooting the unit yet. But i'll give both options a try thanks again.

I added a host to an existing ACL config below and when i do a show run i don't see the changes along with show access-list command. any ideas access-list 5 permit 10.10.30.18

Thanks for the reply no QoS so that works for me.

R1____________ 10 Mbps____________R2 Active link _____________45 Mbps____________ new circuit We are running ospf area 0 and plan on making the new circuit the primary link. My question i just want to make sure I would have to adjust the ospf interface cost on both R1 and R2 . So traffic...

Do i just need to use tftp to transfer the file or can i use scp ?

Hi i'm new to the world of Extreme and needed help setting QoS thanks up front for any feed back . So i need QoS for DNS, mysql tag dscp 41, TCP/UDP 5001 tag dscp 42 all the rest Dscp 43

Can you please post your config .

Thanks "Tarwn" & "Sheco" That worked.

So everyone who posted so far don't know anything about enabling IIS with Server side include pages i take it thanks for the posts. issue resolved.

I don't know do you have an answer. Read the title SSI problem .