Recent content by sierrapacific

I am getting the error on one of my DCs, EventID 1202 Event ID: 1202 Description: Security policies are propagated with warning. 0x4b8 : An extended error has occurred. Any thoughts?

Turns out that it didn't have much information in AD but its name and container, so I used adsiedit and removed the name from the domain controller container.

The old NT 4.0 server is not running anymore, so I can't bind to it in AD. Any thoughts?

I have a old server that had the hard drive failed that was only used for remote dial-in and it was a Windows NT 4.0 server. I would like to remove it from active directory because it was also a BDC. The server no longer runs, so is there a way to delete the servers entries in AD?

I am upgrading a W2K server running exchange 5.5 to Exchange 2003. Does this new server have to be a DC?

dodge20, yes, you were right on with the hotfix. Thanks.

I actually found the answer to my original problem in one of the MS KB articles that as posted on this site before. It all comes down to applying a hotfix from MS, fixed my problem.

Windows cannot access the registry information at \\xx.xxxxx.com\sysvol\xx.xxxxx.com\Policies\{31B2F340-016D-11D2-945F-00C04FB984F9}\Machine\registry.pol with (5). There is only one computer that is complaining about this policy. All other computers work. I have removed the computer from the...

Would it just be better to load 2000 server and then buy exchange 2003?

There are about 100 users in the organization, however only 20-25 use exchagne services. So what happens to the domain that existing on the 2000 servers if I can't join the SBS 2003 server to it..., or does the 2003 server make a new domain, and then the 2000 servers join the 2003 domain?

I'm sure this has been covered, however, I am placing a brand new server that runs 2003 SBS into my existing 2000 domain. I will be upgrading the executive branch users off the exchange 5.5 to exchange 2003 on the SBS. My current configuration is 1 windows 2000 file server (not domain...

My 10.4.7 G5 Macs can't search my new Windows 2003 server. Any thoughts? Appletalk and TCP/IP is installed on the server. I can see all the shares, but I can't search them.

Yes, both are in the same site. I'm sorry but what is IMS?

Alot of my users send mail with out exchange 5.5 server but seem to have their messages arrive at their destination and being directed into the junk or Spam folder. Any thoughts? I've checked all the RBLs that I know, and do not see my servers listed. Is there something I should change?

I have 2 exchange servers, 1 that holds the blackberrys and the users and 1 that holds the rest of the users. How should my routing tabs be setup? On the first exchange server, the first one at this site, is configured to accept inbound mail for the domain and the outside IP of that server and...