Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by shazzam1

  1. shazzam1

    Alarms to email

    Hi, I have enabled mail alert however am not getting any emails? set admin mail alert set admin mail server-name "xx.xx.xx.xx" set admin mail mail-addr1 "admin@xcompany.com" set admin mail traffic-log save
  2. shazzam1

    remote access to my router

    Hi Folks, Yet another device to learn and configure :D Have a new router juniper ssg140. I like to know how to configure it so I can have remote access to the router from my home. here is what I have done: set address "Untrust" "home" my ip add 255.255.255.0 "Remote support from home" set...
  3. shazzam1

    exchange 2010

    Disabled IPV6 and in registry no change below is the after I run the setup. One question does it matter if there is one database that is not functioning correctly it is dismounted. I believe with I could have up to 5 databases with standard ver. Obviously I would like it to be a clean install...
  4. shazzam1

    exchange 2010

    What is the next best thing to do in order to resolve this problem!
  5. shazzam1

    exchange 2010

    nope tried that already...
  6. shazzam1

    exchange 2010

    Everything went fine till I got this message!! By continuing the installation process, you agree to the license terms of Microsoft Exchange Server 2010. If you don't accept these license terms, please cancel the installation. To review these license terms, please go to...
  7. shazzam1

    exchange 2010

    thanks got it, you are right VM makes it easier.
  8. shazzam1

    exchange 2010

    BTW what do you mean by this comment? even spin it up in a VM just to do it correctly.
  9. shazzam1

    exchange 2010

    So, since I have one instance of exchange already installed I can uninstall this first then do the following: Install Exchange using the /recoverserver switch http://technet.microsoft.com/en-us/library/dd876880.aspx Once it's installed, go to Control Panel>Uninstall Programs, select Exchange...
  10. shazzam1

    exchange 2010

    I rather do it right since this will cost my job if it is not done right ;o). If you could be kind enough could you give me a detail instructions on how to perform the supported version. once again thanks, tony
  11. shazzam1

    exchange 2010

    So the irv-exch server does not exist at all.
  12. shazzam1

    exchange 2010

    created one server irv-exch installed exchange had an issue with the server. (these are all in w2k8 R2 hyper-v), so reinstalled from scratch meaning reformat reinstall OS this time needed to name the server xserv so here we are.
  13. shazzam1

    exchange 2010

    Thanks again: here is the info you requested I need to some how remove irv-exch how can I send you a screen shots? Name Server Recovery ReplicationType ---- ------ -------- --------------- MBEX2K10...
  14. shazzam1

    exchange 2010

    Hope I can explain this/? after configuring the new exchange server I see that there is another database that is unknown and it not mounted how do I go about and removing this database? there are also attributes that are associated with this database as well. The new database is mounted and...
  15. shazzam1

    exchange 2010

    thanks so much for the fast response as I mentioned have installed 2010 for two other orgs. so don't understand why this one came up with this message.
See more

Part and Inventory Search

Back
Top