Recent content by shaun123

would have to be a wet peice of string to cut down on losses

u could use a long piece of wire

rfexi and run thatll fix it for good

dont get 2 technical jay944 as ive not touched an md110 since nov last year md whats an md oh i know someone who trys to run a successful company but fails drastically making a quarter of the staff redundant humm sounds fammilar that

try restarting klp1o in low traffic as this will cut all digi calls in progres the o is the letter o not zero

does the extn have any mdns on it if so if any of these are busy that will give extn busy when trying to move its equ

a quicker way that sometimes works is to restart gpp in all lims

try just restarting elp6 in the lim but do it when its quite as this will cut all ana calls

im not sure if it is possible on bc 7 you would have to try it but what about mdn the group hunt no onto a digi phone

thiers no remote test you can do to see if md can see extn if the extn is ringing when you dial it more then likely a cabling/socket/phone fault site visit req im afraid

the quickest way to cure this is to locate the lpu in lim 1 mag o and press the pushbutton once dont do it twice pterwise the lim will fallover and reload itself

hi whosrdaddy do you by anychance work for damovo

ive also had this as well if you have multiple links to lim 2 make the top link is the signaling link when you do a gjlsp if not change it to the top link by blocking the other link temp gjbli:gsside=,gsmult= when comex back executed unblock the link with gjble:gsmult=,gsside= also have you any...

where r u based

its klp1o thats the letter o that you need to restart but be carefull as this will cut all digi calls in the llim not just the 1 card the command is rfpui:lim=,unit=klp1o;