Recent content by shaan00

Thnaks everyone for all you help. I was able to boot the box with the c1t0d0s0 disk (controller 1). I will keep it like this. Thanks again

I can boot of the cdrom fine but I cant boot off the hard disks.

I get "The file just loaded does not appear to be executable" when trying to boot. I have tried the following: boot cdrom -s (solaris 10 installation CD) fsck /dev/rdsk/c0t0d0s0 mount /dev/dsk/c0t0d0s0 /mnt installboot /usr/platform/'uname -i' /lib/fs/ufs/bootblk /dev/rdsk/c1t0d0s0 umount...

hfaix, Your directions were great. I followed them to install svn subversion-1.4.3 on AIX 5.2 ML8. Replacing the 5.3 rpms with the 5.2 rpms. I was getting these errors below (When running step 22 ./configure --prefix /usr/svn/custom) checking for _doprnt... yes checking for symlink... yes...

I let it go though 581 which i understand because the network DNS and Gateway has changed and then it goes to c33. After c33 the led goes blank and then it hangs for hours...

RS6000 7025 F40 Server AIX 4.33 Current it does not boot pass the loading software screen. The last codes it splits out are 581 and the C33. I only have a monitior and keyboard connected to it. Problem seem to have occurred after a power loss in the building. What can i do? And where can i get...

the patch cables are rated for gigabit transfer, The ports on the switch are enable. But i dont get a link light on the switch or the network adapter on the box. I did not set the card for 1000mbps , how do i do that?

I currently have 2 7028-c64 machines that had been powered down. After powering back up they are not on the network. There is not link light on the cable connection. What can i do to test the netwark adapter and possible reinstall the driver if needed. AIX 5.2.. Could this be relatived to the...

I have created an oracle 8i database on solaris 8. The users need to work with character sets in polish and german. There may be other languages in the future. What character set will i need to alter the database to. The users mentioned UTF-16. What is the exact command to change the...

thanks greg and others

Well i was able to connect So this issue was resolved the port was 500002.

I am using DB2 8.1 on AIX 5.1. I want to connect to the database using aqua studios. What do i connect to and how do i find it?

bfitzmai and others, I saw this suggestion on an early post, I tried it and did not see the drive although i had a green light on it. I have tried using different drives and still nuthing. I put the box back into service the 5 drives, could not delay any longer. Thank you all for your...

hi all, I currently have given up getting back the data. I am recreating the databases and repopulating the data. All my users have agreed it would be the fastest solution, Thank you all for your suggests Shaan

I am using solaris 8