Recent content by seawaye

would changing the port from 80 help with not interfearing with getting on line?

when i input this last command no computer could get on line except the server. i had to remove it quickly and did not even get a chance to try the software.

now i can connect from the out side Thank you but i am told that the software we are using must now use the outside address to connect from the inside. i can ping the address from outside but not the inside. is this even possable and does the ping mean that i can not access the outside address...

Thanks for the help but the pix does not liked the extended part of the command

We need port 80 open and a test software says it is open but when i try to connect to the server it doesn't connect. it works fine if i remove the pix. can any one look at my config and tell me if something is wrong? Building configuration... : Saved : PIX Version 6.2(2) nameif ethernet0...

Thanks for your help but when i put in the last command i get this message: ERROR: static overlaps with XXX.XXX.XX.146/80 to 192.168.110.1/80 Usage: [no] static [(internal_if_name, external_if_name)] {<global_ip>|interface} <local_ip> [dns] [netmask <mask>] [<max_conns> [<emb_limit>...

We need to open port 80 from outside to ip 192.168.110.11 everything i try doesnt work and gives me other problems. Can someone tell me what i need to input to make this happen? Here is my config now. Building configuration... : Saved : PIX Version 6.2(2) nameif ethernet0 outside security0...

We have a pix 501 that we are trying to open port 80 on and it shows an un parsed command of access-list outside_access_in permit icmp any any can someone tell me how to delete it or show me what is wrong that we can't get to port to open? here is the config as it stands now. Thanks Chris...

I am told all I need to do is open port 80 but i can not connect. I will post my config before trying and after trying to open the port. Currently the pix is showing an unparsed command of access-list outside_access_in permit icmp any any can someone explain why and what i am doing wrong...

at start up it blue screens then restarts same with saf mode no recent changes

stop:0x000000ED (0x82B7EB20, 0XC0000006, 0X00000000, 0X00000000) any ideas

Thanks For Your Help!!

Is there a way to take the NT server from a BDC to a member server with out a reload?

We installed a 2003 SBS Server as a PDC. Since then we have been getting these error code on the BDC NT Server 7023 & 5721. Error 7023: The Net Logon service terminated with the following error. The Sam database on the Windows NT Server does not have a computer account for this workstation...

I was trying to change a path for ccitcp2 I was able to change this in the registry