Recent content by seanform

Because i need to connect an rj 45 device wirelessly and cannot use a wireless nic

The main router is connected to a DSL Modem via WAN port and to my 2 pcs via LAN (1,2,3,4 ports). The bridge or 2nd router is just connected to an Xbox. It gets internet wirelessly from the main router. NAT is enabled

Hello to all. I have installed a DTK router as bridge at my father's house. He has a Trendnet router and the DTK worked as bridge without problems. I bought an identical DTK router and did the same settings at my house but it does not seem to work. DTK bridge settings: set operating mode to...

You sure it is ehci not ahci? ehci has to do with usb butahci with sata

Ate you using an old version of ghost? Are you using ghost in win or booting from a cd? I clone hundreds of ntfs drives....never had a problem. If you clone an entire drive there is no need to mess with partitions as partiton table will be cloned as well thus cloned drive will be bootable.

No need to edit anything. Just install this software and it will do everything for you. It can even swap the drive letter.http://www.ranish.com/part/xosl.htm

It does not read commercial cds. Originally it was installed with nero but i've also tried burning with xp. Yep i'm sure it has a faulty cd laser. Thanks m8s :-)

It does not recognise CDs. It works fine with DVDs however.

Yes. That can be the reason. I did not know that cd and dvd reading/writing have seperate lasers.

Hello, I have a NEC DVDRW Model ND-3540A. It works fine with DVDs. However when I put a blank CD it does not recognise it. Nero gives 'no disc in drive'. I have tried it on different PCs. I have also upgraded its firmware from 1.01 to 1.04 but problem remains.

Well I am not sure if I am posting this thread in the correct place! I have written a program in MS Access. I want to create a button that copies a record to the end of the list. I can do this by selecting a record and using copy and paste but would like it to be done automatically. Do you think...

The PCs log on to a domain. However different users log on every day and some of them do not have a clue how to change regional settings.

Hello everyone, does anyone know how to set up a group policy to freeze the regional settings for all users ie even if a new user logs in?

Hello, I work in a hospital and we have several computers on the network. By default our computers's date is set to mm/dd/yyyy and we use dd/mm/yyyy. Here different users use the same PCs. The problem is that when I change the regional date settings for administrator, when users log on, the date...

You do not need to buy a new fan. Disconnect mains. Open PSU and remove the fan screws. On the side of the fan you'll see a sticker. Remove it and than you see a small plastic lid which you can clip off. Put some oil in the nipple and put the lid back on. Put everything back in place. Switch on...