Recent content by sdruhl

Does anyone have any good instructions on how to cluster Exchange 2003? I have to setup a cluster for a client and have not done this before. Any info would be appreciated.

All, I had a major problem with trying to upgrade from NT 4 to Windows 2003. Here are the details. I had an existing NT 4.0 domain. I purchased a new server to run W2003. I installed NT 4 on my new server and made it a BDC. I loaded SP6. I then promoted the new server to be the PDC. I then...

Does anyone know the commands to make the Pix 525 Firewall accept VPN traffic with ipsec/tcp? The firewall is currently accepting ipsec/udp traffic and I need to be able to accept ipsec/tcp. Any help would be appreciated.

Does anyone have a sample config file for setting up a Pix 501 with VPN? Here is the situation: I have a Pix 501 filtering all my I-net traffic. I want to allow 2 remote users to VPN to the Pix with the Cisco software client. I checked Cisco's website and they had a sample config, but I don't...

HW Client is in network extension mode. I will follow the previous artilce and make sure we aren't missing anything. Any other ideas on why this isn't working??

I cannot ping the Hardware Client's Private IP (192.168.2.1) from the concentrator. NJ is on a 192.168.1.0 subnet. I tried adding a static route on one of my servers but that didn't work either. I did route add 192.168.2.0 mask 255.255.255.0 192.168.1.13 -p 192.168.1.13 is the inside of the...

If someone could help me with this I would appreciate it very much. I have a Cisco 3000 VPN Concentrator in NJ. I have a Cisco 3002 Hardware Client in England. England can talk to all servers in NJ accross the VPN with no problem. However anyone in NJ cannot talk to anyone in England. How do I...

Yes the traffic is inbound to the local machines. I'm not sure I understand the phonyport1 command. I assume if my machines IP was 192.168.1.1 I would put this after the phonyport number. What would I put instead of phonyport1? Thanks again

I have 5 computers on my LAN all connected to the i-net with a DSL line. I want to use the Pix 501 for my firewall. The customer has only 1 static IP from the DSL carrier. The customer needs to be able to RDP into there machines with XP Pro. How do I setup PAT so that all users can RDP to the...

Can anybody assist me with this????

OK. I deleted the nat (intf2) 1 0.0.0.0 0.0.0.0 0 0 I also changed the global intf2 to the following global (intf2) 10 interface. I still cannot ping the web server in the DMZ or access the web page. Is there anything else I have to do?

ok, sorry for the delay. Here is the current config. I had to delete IP addresses,hostnames etc. because this is a high profile client. I am sure you guys understand. The goal here is to get the inside Lan to access a web server in the DMZ. Any help is greatly appreciated. PIX Version 6.3(3)...

I have removed the access list and still no good. I have allowed ICMP from the web server to the LAN.

Thanks for the reply 308Win. I have added the global dmz 1 interface command and i have an access list applied to the inside interface to allow communication to my web server. i also have the nat command for the inside in there. It's still not working. Any other ideas?? Thank You

I have a web server in my DMZ. I have a local area network that needs to access the webserver. We currently cannot ping the IP address assigned to the webserver, outisde or inside. Is there anyway of doing this besides putting a nic in the server and connecting it to my lan? I have a Pix 515...