Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by sawysc01

  1. sawysc01

    Help: Use Router W/ Linux Server & Windows Lan

    Rhythm User fluid11 Thanks for the help with this issue, my config now works properly and I thank you again. I do have one last issue. I have 5 static IP's assigned to my account and I know that each new server I connect I can assign them 1 ip address. But is there away to assign 2 Public Ips...
  2. sawysc01

    Help: Use Router W/ Linux Server & Windows Lan

    Is there away to add 2 IP addresses to the one eth0 card? I see in the Network Configuration menu of Red Hat that if you select the card and click configure and then edit it has a General/Route/Hardware Device Menu In the General Tab 192.168.1.20 (IP) 255.255.255.0 (Subnet) 192.168.1.1...
  3. sawysc01

    Help: Use Router W/ Linux Server & Windows Lan

    fluid11 I tried the config you suggested and yes I can connect all computers to the web but my domain name now defaults to a blank test/ssl page not to my domain index page. I have tried putting it on the DMZ zone and tried forwarding port 2222 and enabled it. My control panel is reached by...
  4. sawysc01

    Help: Use Router W/ Linux Server & Windows Lan

    This is what I have done but I don't know if it's correct. I have left my eth0 card with my public static IP address. I added a 2nd NIC eth1 and connected it to the router and gave it a static IP of 192.168.1.20 I connected eth0 to the router. I connected the router to the cable modem. I set...
  5. sawysc01

    Help: Use Router W/ Linux Server & Windows Lan

    I was using the webmin control panel, but could not setup reseller hosting accounts so I switched to the DirectAdmin Control Panel at http://www.directadmin.com and the software will only work with my Public Static IP Of 24.56.*.* I can set this IP in the Router WAN Port... Wait a minute...
  6. sawysc01

    Help: Use Router W/ Linux Server & Windows Lan

    I have read so much trying to grasp this and at this point I am totally confused can someone please try and break this down for me. What I am trying to do is this.... I am running a Linux Red Hat 8.0 Server connected to a Cisco UBR 900 Cable Modem with Static IP Address. I have the server...
See more

Part and Inventory Search

Back
Top