Recent content by sathya1712

Is it for all calls? Have you tried to see if there is anyone fiddled with coverage path? Is it problem with single user or a group or with the whole switch?

- Are the T1's provisioned as PRI trunks by the provider? - Did you reprogram it as PRI trunk or Tie trunk? - Can you copy and paste your programming on PBX? Thanks,

The Nortel guy had to make changes on his trunk so the PBX accepts "digit DNIS" but not just the "digit"! Now its fixed and working fine! Thank you for your help!

Apart from TAC code we are dialing local extension on the other end!(Nortel extension) The tech on the other side assumes DTMF tones generated by Avaya is not being validated by Nortel!!! Aren't they all follow ITU standards?? Thanks for your feedback! Any other thoughts to help the situation...

Hello all, We are here having a strage problem while trying to connect a t1 between Avaya S8700 and Nortel PBX, the channels are in-service/idle, but when called the number on Nortel using TAC, a wrong extension or same extension rings for all the calls!!! But it works fine other way...

Thank you very much, dwalin!

Just a quick question: We are trying to deploy CM - 2.1 but was wondering if any one knows if 2.1 has any constraints in fuctionality when compared to 3.1? I know 3.1 is enhanced, but if we have just 2.1 its still sufficient? Do you have any idea about how much extra 3.1 may cost? Any helping...

Ok, just check with your company if they have any direct contact with Nortel, or if your company has a registered site ID with Nortel, in that case you can create your own login account with your company e-mail id.

8612 works just fine! I am mapping it to working extension! Well now I have fixed half of the problem though! After changing service type to "CBC", it started working, but the calls will land only on the channels belonging to primary D channel board!!! Its really getting on nerves!!! Any...

can you tell me something about your company, your position and your relation to nortel?

Did you find what you wanted?

Do you guys think it can be an issue from the provider end??

list trace tac 26 LIST TRACE time data 13:58:37 Calling party trunk-group 6 member 24 cid 0x12b 13:58:37 Calling Number & Name xxxxxxxxxx NO-CPName 13:58:37 active trunk-group 6 member 24 cid 0x12b 14:02:04 TRACE COMPLETE trunk-group 6...

I did all of the above, and yes I get busy tone after hitting the trunk! Any suggestions?

Here is the trunk display: display trunk-group 6 Page 1 of 10 TRUNK GROUP Group Number: 6 Group Type: isdn CDR Reports: y Group Name: MCI-42/HCGS/606-849/851/734 COR: 80 TN: 1...