Recent content by Saedyn

I'm installing SCO on a JBSI Terrian Server with a 700MHz Pentium, 128MB's of memory, and a IDE hard drive. I'm not using any BLTD's and I'm not to familiar with MPI.

I've read that article and I've searched all over SCO's website but I have not found anything close to the problem that Im having. I'm getting this error during the installation Im pretty sure its not a hardware problem.

I tried reinstalling SCO 5.0.5 and I get the error: panik double fault k_trap error 0x00000008. I fdisk'd the hard drive and the mbr and then formatted the whole drive. I tried the installation again only to get the same error 5% through the install. I also tried some new RAM only to receive...

96 Megs. I do have plenty video cards and I'll try that after I try a new hard drive. I'll let you know.

Im installing 5.0.5 on an old HP. Im not sure about the model because it has no writing on it. It is kind of cool though because it has its own screen on the box. It has a 133mhz MMX on a motherboard that fits into a ISA slot with a PCI slot on the end(not sure what the name of that is). Ive...

Im not sure what was going on but in the BIOS the IDE Secondary Master and Slave PIO were set to Mode 0. I changed them to auto and started the installation over. This time the IDE Cdrom was automatically selected. But now, a ways further into the install I am getting "Panic k_trap...

thanks

what lot of help you are

Im installing SCO and using an IDE cd rom I just hooked up. When I get to choose media device, I choose IDE CDrom but it tells me to install a host adapter. HELP

It is an IDE cd rom drive and SCO is a flavor of unix. Im not sure what an ATA card is but I know its not in connected to a SCSI card.

I'm trying to install SCO and I just added a CD-rom drive to do this. During the installation it says to choose media device...so I chose IDE CDrom which it then tells me to install a host adapter. Any help would be well appreaciated.

The shell may also be shot and just needs a reboot to gain telnet access.