Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Sabap
-
ICMP question
No.. 1 program called "nmap" comes to mind while port scanning. If you use the switch: -P0 <---zero it will not send pings. I believe it will actually try and make connections to all services that reply. Matt -
UDP Forwarding
I am setting up a SIP phone on my network. I need to open a range of UDP ports to make/accept calls. Givin the string: ip nat inside source static udp 172.16.5.100 [port] interface Ethernet0 [port] Is there a way to specify a range of ports in a single command? Instead of writing 20 static NAT... -
2610 trouble
Thank you for your help.. to answer Degg's question. There are 2 Different organizations in the same building. They are also sharing a 3com NBX 100 Voice over IP Phone system. One of the organizations is a medical company. They want their DATA on a different network to insure security. However... -
2610 trouble
Password: VisionQuest>en Password: VisionQuest#sh run Building configuration... Current configuration : 753 bytes ! version 12.1 service timestamps debug uptime service timestamps log uptime service password-encryption ! hostname VisionQuest ! no logging console enable secret 5... -
2610 trouble
I have a Cisco 2610 router in a local county complex that houses 2 different agencies. I have separated their networks by using Vlans. I use the single ethernet interface with one sub-interface for my router connection to the trunk port of the switch. I am using dot1q 2 encapsulation on the... -
VPN Help
Ok... first of all I have a Cisco 2514 Router running IOS version 12.2(12a). Ethernet 0 is connected to my cable modem and Ethernet 1 is connected to a 2900 Catalyst switch. The router is running NAT and there are 3 Windows XP machines and 1 Linux Red Hat machine on my network. I will post my... -
Cisco 1603 problem
Make sure the Bits per second on the port settings is at 9600 (In Hyper terminal). Hopefuly you are using a Serial port with a transiever (COM Port 1 or 2). Tranciever plugs into a serial port, then you plug a roll over cable into the back of the tranciever via RJ45. Genarally Rollover cables... -
UBR924
I just bought a new ubr924 Cable modem / Router. My experience with the Cisco IOS has been with 2500, 2600, 7200 series routers. I have 2 problems.. 1) For some reason when I press the "up" arrow key, it not only puts the last command I entered on the screen, it also automatically...
