Recent content by s3k

1.get the dialtone. 2.dial the extension number 3.if the person is busy you will get busy tone 4.then press Override Key Think Globally, Act Locally

HEllo i need a solution on this. I have a Voip router where i can connect to 2 different Session Targets. I also have 2 leasedlines to internet thru which i can reach the session target. One: How can I configure router in such a way that all traffic going thru my first leasedline(SER 0) USES...

thanks buddy Think Globally, Act Locally

I had some prbm in XP, where when i access reports it says cant open certain file. I changed the security settings of the windows user and give him full control for the symposium folder(if poss program files folder itself). it worked.. u can try the same.. Think Globally, Act Locally

Agent performance report shows DN calls which are far less than calls reported by CRM. i assume that AGt performace is displaying only contact calls..But what all calls are considered as Contacts by symposium. SOmeone help me.. thanks u in advance!! Think Globally, Act Locally

yes it worked with pbx as usr side and router in net side. Think Globally, Act Locally

ya i amde a research on that . It needs a netsentry component which is not supported on latest PCRs. Its bit complicated coz the nature of passport file system. we have to ftp the filter and store inside passport and call it thru command console. but its not that tough though. Thanks...

Pls help me How to set up filters in Passport 7400 mux. Can anyone help me send the docuument on this....pls i want to allow/disallow certain IPsaccess my Internal network. thanks in advance Think Globally, Act Locally

how do i set up password protection to make long distance calls. not for all extensions..but only for a set of them.. I need the system to ask password before any person can dial-out long distance calls. Has 61c the flexibility of asking the user for assigning/changing the password once...

yeah even i was in need for that DPRI card documentaion. NTCK43 i think is the card number. Think Globally, Act Locally

its 2 way dids, inb and outb.. Think Globally, Act Locally

yeah i wanna make some groups.. say group 1 give permission for international calls group 2 allow only local calls without mobile group 3 allow local and mobile calls etc and assign this over the did trunks Think Globally, Act Locally

friends I have DID trunks pointing to the telco loop. Can i configure access restrictions based on NCOS/NFCR on these trunks. I had configured the same on TIE trunks and woring fine, but cant do this on DID trunks( MERL also says can't). Is there any other way i can set it up? What i did with...

friends I have DID trunks pointing to the telco loop. Can i configure access restrictions based on NCOS/NFCR on these trunks. I had configured the same on TIE trunks and woring fine, but cant do this on DID trunks( MERL also says can't). Is there any other way i can set it up? What i did with...

hi has anyone here integrated a 61C dualPRI card to a Cisco 2620 router with E1 voice module. I wanna know which NodeTYpe (SIDE)to be set in the Meridian. USR or NET. cud any one help with some configuration points to follow. rgds S3k