Recent content by rvw

yes we have. I need to have preprinted form in tray three and do not want other reports printing on them. Now we print from both trays for reports, which one has paper.

this is a LJ4000n not a 400 sorry about that.

I have LJ400n printer that shows in the config as tray 3 to be preprinted but when I do a print config it come out as letter and when I send a job to it with preprinted it will not work. Can some one help me with this change.

Can someone help me find the basic setup for a call center. I need to setup a hunt group number so difference station can login and take calls for that group. I need to set this up from the start so I'm look for a basic setup information. I have C.M.2 on a S8700 with 40 logged-in ACD agents...

Thanks very much Dustinn3 that was what it took.

I have two station where the lines ring on and the doctors do not what the station to ring can someone help me with the programing with winspm to change this.

I need to have another DID number ring on a 2420 that has send all call to another Ext. My CEO has his station setup to send all calls to his secretary. He would like to have another line for incomming calls from special people (his wife) to ring at his station. Can someone help me with this...

they are ISDN-pri two-way but I need to send my three digit DID's down them also plus I have some four digits DID's they say theyare going to send four digits down all lines how do I make my switch just use the last three digits for the three digit numbers and can I sent up 7 lines to have toll...

sorry about that they are ISDN-PRI

Can someone help me with the setup of smarttrunks on C.M. 2.0 with S8700. If there is some help files that would be great. Need to know what all need to be programed to make them work.

can I do this on the admin port for programing also for I think its bad also because can not get WinSPM to connect but I'm waiting for a 355a adapter.

I have used both pin out with no luck maybe the admin port is bad can I do a reset on it someway?

I guess what I should have said how do I reset or get make the station work? There is now no dial tone or do any of the keys on the phone. I test the phone at another station and it is ok.

I had a Merlin magix station that a person plug a modem into and now the phone has no dail tone or display. Can someone tell me where to reset the port?

Can someone give me a heads up on where to get the 355a adapter and the cost?