Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by RuneX21
-
Cisco Frame Relay T1 Config
Thanks again everyone, got this up and running. As a side question I am having problems forwarding specific ports on these.(Incase anyone is wondering, I normally deal only with servers, firewalls, and software(programming and web design) so my knowledge of cisco equip is rather limited. I was... -
What is easiest way to learn Netscreen firewall concepts?
I too was thrown into a project that involved working with Netscreens and VPN's. I found them to be extremely easy to pick up and I had no experience with any of the others you mentioned. Although now I have had the oppurtunity to work with a PIX environment. Basically if you can handle a PIX...- RuneX21
- Post #3
- Forum: Security, hacker detection & forensics
-
Question about the "change password" option in OWA in LAN environment
Actually the change password feature does not work by default. You have to setup a SSL security service in order for it to work properly.(I probably stated this wrong, but in short, you have to setup a security function in IIS to get this work properly) Here is a link that will help you set it...- RuneX21
- Post #2
- Forum: Microsoft: Exchange
-
SMTP Error 550
I am used to the relay denied errors by now, but recently I got an error that has me stumped. It is only to one domain as I have never seen this before. I had thought it was a temperary thing, but it has been happening to this one address for the last 2 weeks. Any idea what causes this one, I...- RuneX21
- Thread
- Replies: 0
- Forum: Microsoft: Exchange
-
Cisco Frame Relay T1 Config
I had it shutdown on purpose, I activated it when I was actually running it.I have a thing for not leaving interfaces running even if they dont work.I forgot to pull the line when posting so for that I am sorry. Thanks for all the assistance, after a few hours on the phone I was able to get it... -
Cisco Frame Relay T1 Config
One more piece of info,here is the current running config for the serial port if it helps any. I think the issue is with the ISP router and Network ID though since I have not input that info into anything yet. interface Serial0 ip address A.B.C.D Y.Y.Y.Y encapsulation frame-relay IETF... -
Cisco Frame Relay T1 Config
I am trying to configure a new T1 in a Cisco 1721(IOS 12.2) Modular Router. I have a Wic1 CSU/DSU card inserted and the line connected. I have setup the DLCI, the LMI type, and the encapsulation method. However it cannot connect. The only information I was given is the following. Encap -...
