Recent content by Rudh

Can the message waiting indication LED be activated by a Centrex mailbox on a Norstar T7316e set ? The mailbox is providing the studder dial tone. Can this trip the Red message light on the T7316e set ? Do we have to request a special signal from the LEC ? Norstar Mics 6.1 with LS/DS analog...

I have a CS1000 Release 3.00 with FTR block not displaying the prompt to change BFS_CFW to no. I believe the patch for this is MPLR 05683 and the Avaya ESPL doesn't have it for this release. Anybody have it out there for Release 3.00? BSFE NO ASPCT 000 FXS NO DFLT_LANG ENG STS_MSG MSG01...

You may be reaching full capacity for voicemail Storage. If you login to Meridian Mail and check system status it will indicate warning message of capacity reaching full capacity. To check all mailboxes with storage used go to user admin press find (F5). Then list all mailboxes it will show...

Should work ok. If your using a T-1 CSU they have settings for cable length from 133 to 633ft.

If you use Procomm use keyboard editor found on Options Tab and click on F5. Enter under normal: Sent Text then under contents enter: ^[OM then save. This should make F5 work if your using Procomm.

Noticed two patches in the system need replacements. MPLR19888 is defective the replacement is MPLR19096. MPLR18136 is obsolete the replacement is MPLR19885. New Deplist is #9.

Your upgrade says no Deps or PEPs in service. If they are installed they are not going to list (ISSP). Need to have your vendor if Nortel authorized to put them in service through PDT if there is PEPs or Deps installed.

Can you Print out your ISSP in LD 22 and post it. It may need a Patch MPLR16453 One way speechpath fix.

Ground start it is. Good call Hawks.

If might try if you want to fix yourself. This might work. Are these your Symptoms: No access to Meridian Mail. AML link 9 Layer 2 enabled layer 7 down disabled. BUG: BUG4111 BUG: BUG4111 Invalid ESDI input Mail agents stat busy (BCS MSB LOGGED OUT) Cause: LSL and AML...

Need to install patches MPLR11480 and MPLR12003. Need to use authorized Nortel Vendor to install. This fixes this problem. I have had this happen in past.

I performed a upgrade on Large Option 81C(Hotel) and I had to change out all NT8D09BA REL 1 thru 8 due to Nortel Bulletin PAA-2002-1548-Global Revision 2.0. Nortel replaces all these card free of charge. Just have your vendor use this bulletin to produce RMA# with Nortel to have these cards...

Roll cards. Take a Analog NT8D09 that you know works and swap with the trouble card. If problems still happen with problem card in another slot on different TNs/DNs the card needs replacement. Also see if the knowing working card in trouble slot TNs are in working condition. If so the card that...

Sorry not to respond quickly. I have this on TTY#2 and the connection is about 75 feet away from the phone voicemail system. It has a short haul modem interconnected to cover the TTY distance. I changed that out with a replacement. I also tryed the ACK and its not recieving from PMS. I talked to...

If your familiar with PDT/DEBUG. Try going into debug and perform cttest Ctrl-B at boot up instead of Ctrl-I . First perform a XBK on phone system. This test does through test on Flash Card and wipes out everything on it. When test is done. Try upgrade again. Must install 3.0 with no database...