Recent content by rsmadhava

If the connector is exposed to hot environment, I would recommend 3M Ultra High Temp Hotmelt connectors. These are designed to work upto 100 deg C.

Level II refers to TSB-67 standard. This is a testing standard for CAT5 systems. This standard is obsolete now with introduction of 568-B.2 More info is at http://www.hubbell-premise.com/Technical/TSB67.asp

Is there a international standard for equipment mounting racks ? Which are those and from where I can get them ? I am searching for mechanical dimension details which i need to follow for the equipment which I am developing to meet the standards.

I have a situation where the CAT5e cable length is short and I have no alternative excpet use some splicing system to extend the length. What products I can use to splice CAT5e cables ?

Mode conditioning patch cord is used in a situation where the backbone cable is multimode and the optical interface on the switch port is having 1310nm laser source. Currently you have monomode backbone cable already installed and the switch ports are having multimode (I presume it as 850nm)...

606A seems to be very complicated. Is there any practical, simple way to document ? Are there any templates available to share ?

What is the best way to document patching details in a wiring closet ? Is it a normal practice to put number tags to bothe ends of RJ45 CAT5e patch cords when used for patching ? Can any one share templates of good practices in documenting a cable infrastructure

Has any one used Krone LSA-Plus module for data transmission between 2Mbps to 100Mbps ? Is it rated for such application ? Where can I get complete specification of this product ?

In that cisco document, there is a mention of type of clocking which also influences the distance of V.35 cable. I did not understand that fully. Can any one explain ?

One of the cisco documents recommend length of V.35 cable versus transmission speed. This document also refers to a graph published in EIA422 standard which gives further details. Can any one provide this graph ? Also some practical recommendations about this subject is welcome.

I have given 192.168.10.1 to ethernet port and 203.100.5.1 as secondary address to that port. Can I use this secondary address (alias IP) to unnumber a serial interface ?

Is it a normal practice to label both ends of an RJ45 to RJ45 patch cord ? If yes, what is the method used ?

I have a few questions : I have a router with 2 serial interface and one ethernet port. Both serial ports are connected to different networks. 1. Is it possible to use IP un-number to both serial interface ? 2. The ethernet port has an IP number which i use to un-number s0. I also have an...

While maintaining a distance of 1/2" is possible with 8 position jacks, I am finding it more difficult to do that in IDC modules like Krone LSA and High band modules. Is there any seperate standard for removal of sheath for terminating on IDC modules (8 pair or 10 pair) ?

Thanks for all replies. If any of you find a documented recommendation on this, please post it.