Recent content by rsadf2006

Hi all I have CS1000S working on release 7 installed on near site . I tried to connect it with Avaya ( IP Office) system installed in Remote site through ISDN_PRI. The problem is when I reset the DCH and LOOP form Near system, the link and channel up but after some time it becomes down. I...

Thank you Mr. GHTROUT I tried your solution and working fine

Hi all I have Opt.11C Rel. 3 My problem comes when I forwarded my Digital extension ( 3258) to my colleague's Digital extension (3259) . When any one call me on (3258) it directly goes to (3259) this OK,but the caller's name does not appear on my colleague's telephone set (M3904). Is there...

Thank you Mr GHTROUT I appreciate your quick response

Hi all I have CS1000M Rel.4.5 I want the incoming line ( analog trunks ) toward my system to give me caller ID. Is there any way to enable this service. thank you

Hi SL1M1 I already change it to CDP but unfortunately the result same (Nothing change) Thank u any more notes

Hi all For now we have not received any comment about our system's configuration If there is any answer we appreciate it' Thank you

In the following lines you will find the configuration for DCH , Trunk and Route for both sites For site 1 DCH configuration ADAN DCH 27 CTYP MSDL GRP 0 DNUM 11 PORT 1 DES SITE 2 USR PRI DCHL 23 OTBF 32 PARM RS422 DTE DRAT 64KC CLOK EXT NASA NO...

Hi all first, I would like to thank firebirdscrambler for his post solution , but when I did same problem still there. Second, I will explain again my issue " I have two site connected to each other through TIE trunk. And I define LSC xxx for site 1 and yyy for site 2 but when...

Hi all I have an problem , when anyone calls from remote system ( CS1000M rel. 6) I got H2586 instead of 2502586. It means there is no DSC number. I have tried to resolve this issue but unfortunately I could not do anything. Thank you

Hi all I have analog trunks (COT) coming from telecoms company to my system (CS1000M rel. 4). And I have billing system connected to my system But If i want to see which number called me in the billing system I couldn't , I only got route member. Is there any way to resolve this issue...

Hi all In posted conf. u 'll find the configuration which I implemented in both side using E1 channel( One Side CS1000M and Other is CS1000E) When i tried to test the call between two site I could not, once i dail 81 i got a tone but when i dail any extention in the remote site nothing...

Is there any wrong with previous configuration thank for all

Thank you M1spezi I did it but once that emplyee return back to the first number could not hear anything I will post the conf. on that number prt TYPE: tnb TN 240 0 02 00 DATE PAGE DES DES 240002 TN 240 0 02 00 VIRTUAL TYPE I2002 CDEN 8D CTYP XDLC CUST 0 NUID NHTN ZONE 000...

Hi everyone We have CS100M Rls.4 I faced a problem with telephone "i2002" when he is talking with someone on prime extention, he got a new call on Call waiting, Once he answer that call the first call automatically droped Could you tell me the way to allow that person to return back to the...