Recent content by rrgg

Hi all, I have one PIX 506e, on inside lan there is one PC client, on this client there is SSH Sentinel VPN Client software for connect this PC to a Remote lan protected by Zyxel Router/firewall. When I activate Sentinel software, VPN Tunnel goes ON but the taffic doesn't work, for example is...

Hy all, I improve one bi-directional full site to site VPN Net1 (Cisco Pix-506)- Net2 (Cisco Pix-501). All works fine but now I need same restrictions: I need permit all Hosts from Net1 to only one Net2 Host; also need permit all Hosts from Net2 to only one Net1 Host. Can someone help me...

Hi all, I have one Cisco PIX 501 connect by outside interface to a Telecom Router. This Router show his state by web page. The router automatically each 5 minutes updates his tables and publish IP Addresses of each host connected, on his web page. I think that Router capture IP Adresses of any...

Hi all, I need to install and configure ISA Server 2004 as Proxy Server only. Isa must be installed on my Windows 2003 Domain Controller. Where can I find any informations about this configuration? Note: My Lan is already protect by Cisco 506 Firewall. Tks all.

If you want to reset password to factory default you can follow this document: http://www.cisco.com/warp/public/110/34.shtml After this if you want to reset configuration to fatory default you write this: WRITE ERASE REBOOT Bye.

TKS for answers. I decide that PIX is cause of the problem because without PIX (I set on one PC the same IP address of the PIX) the PING work correctly. I need to adjust this because AS/400 has MTU size set to 1496 and is not possible change it. In access list I alredy have: access-list...

Thanks for answers, The MTU size is default (1500) sh mtu --> inside 1500 outside 1500 I hope impossibility to fragment packet. How to do this?

Hi all, I have this situation: PC - PIX 506 - Router - WAN - Router - AS400 this is my problem: I ping by my PC the remote AS/400 by this command: PING AS/400 -l 1472 I obtain correct response. PING as/400 -l 1500 I obtain time out. It seams my PIX 506 doesn't fragment packet. How to solve...

Hi all, My network is protect by Cisco PIX 506. When my firewall is under port scan or similar attak I need to send alert to the network administrator. Also I need to store this attak log. Ho to improve this??? Tks for answers. RRGG

Thank you for answers!!! The log-on possible is: By Terminal Services By FTP By HTTP rrgg.

Please, if possible, someone answer to the question. Thanks.

Hi all, How to discover IP address of who is being attempt to unauthorized logon to Windows 2000 Server? Thanks.

Any idea??

How Cisco PIX verify Client Certificate validity if it was released from Windows 2000 CA??

Is Windows 2000 CA necessary? Can Pix 506 E release certificate?