Recent content by rodolfopereira

This is an example : The router 1 is in standby and the router 2 is active. Router 1 interface Vlan101 ip address 10.100.50.5 255.255.255.0 standby 101 ip 10.100.50.10 standby 101 priority 50 standby 101 preempt Router 2 interface Vlan101 ip address 10.100.50.15 255.255.255.0 standby...

No, really no. Use a phone and test the pstn lines to be sure the problem is not there. Also test the analog trunk and the wiring.

Confugure scpw = 4 and define this on the tn configuration. After this dial spre + ffc code + scpw + forward dn.

To have a perfect redundancy you need to have a pair of routers with a T1 card each one, but if you don´t have it, you can use one single one with two T1 cards. In both cases you only need two single T1 Card, not a dual T1 Card. Regards. RP

Delete the VTP Domain the message will desapear. Regards

Hello Try yo use a crossover cable between the pix and the router. Be sure the ethernet interfaces on the pix and the router are UP (perform a no shut into the interface configuration) Try to connect your laptop directly to the pix and look if the pix ethernet interface change up...

Hello For the windows box you can use yats (use google to find it). You can sync the windows box and the cisco router with the NIST http://tf.nist.gov/service/its.htm this is free. If you need more help with the configuration, send me an email. Regards... Rodolfo

Hello Is possible that the 500 port is not open on one side, this cause that the VPN only can be stablished from one side. Regards. Rodolfo

Hello... I make in the past E1 connections over 80 meters using UTP RJ48 and a 120 / 75 Ohm Balum on the side of the carrier and work fine. Regards... Rodolfo

Hello.. If you carrier provide you a T1 to make the point to point link between the two offices you need two serial interfaces one for each 1721. If you don´t have the serial interfaces for the 1721, you need to change the T1 link to an ethernet link, (a lot of carriers provide this...

Hello I think is not a good idea, please do not use special characters. I had a major problem years ago with a 11C. Regards Rodolfo

When i try to log in in a OTM Server using a Terminal Server Connection with the server, the OTM give me the follow error Can´t Create OTMAuthentication Instance Authentication: 800401a...But if i log in directly on the Server i can log in without problems.....

Is Usefull when you have IP overlap

If yoy have IOS : Int f1/2 switchport access 100 If you have CAT OS Set vlan 100 1/2

On your system you have no idle lines on the outgoing route. Check the trunks associated to the outgoing route.