Recent content by RobG2001

I currently have two internal Win2K3 DNS servers on my internal network that had been working fine. I tried to upgrade my PIX os from 5.1.2 to 6.3.x but that stopped all traffic. I downgraded to 5.2.9 which allowed at least email to flow in again. The problem is that my internal DNS servers now...

I did this for a 6009 but we're using the CatOS so we had to configure "auxillary vlans" for the ports. I did set my 3550s like your preferred method as well as running the DHCP on the switch itself instead of on a Windows server.

Solved: I got a different tech out here and he was able to figure out: the previous tech had an option that blocked the digits coming from the fax card (I think it was option 801 int the COS screen). Once this was done, the faxes were able to go out. Thanks everyone.

They're saying it's the "loop current lost"... See his comment. I have no idea what that means.

We currently have successfully set-up incoming faxes to our Faxserver but are having trouble setting up outboung faxes. We are using a Brooktrout TR1034+P16H-T1 connected via a STP cable to the SX200. The PBX tech we had here couldn't figure it out and said he wasn't getting anything from the...

That is very interesting. Mitel is claiming we're the only one they know of having this issue. Do you have any specific info you could give me regarding the issue in Calgary on or off the list? I'd really like to tell them that xyz company also had a very similar issue that Mitel is aware of...

I'm a network guy and yes Mitelman, you're right. They did make me send them my Cisco configs and still blamed them network. Finally I made them plug the phones into the 3300 directly with a power brick and yet we were still getting the problem. After that, they said it could still be the...

Specifically I'm sniffing everything on one port which should be getting the tx and rx from the phone.

I'm doing as an exercise in trying to learn more about VoIP. I like to understand everything on my network so when something goes wrong I can have a good idea of where the problem is. In addition, we've been running into some serious bugs in the 3300 where I've been asked (by Mitel in Canada)...

I'm using Ethereal, a Mitel 5220 IP phone and a Catalyst 3550 switch. I am able to create sound files using the packets I've captured but they contain only one side of the coversation. Is there something I'm missing on listening to RTP? Thanks Robert

I've had nothing but problems with those VWICs. I called TAC and one of the engineers said their meant more for voice than for a T1. On a point to point one end is set to clock internal and the other end is clock to the line.

By setting it to trunk mode it should take all vlans. The other thing is that the PCs can ping each other but not their gateway.

I'm not sure what I'm doing wrong but I can't get my vlan routing to work with my subinterfaces on a 3550 switch. the port on the switch is configured like this: interface FastEthernet0/21 switchport trunk encapsulation dot1q switchport mode trunk no ip address the Router is set up like...

I'm learning the CatOS and so I'm having trouble with my config file. I did some changes to the running config and now I want to save it to the startup config. If this was an IOS, I would do copy run start and that would be it. How do I do it now? When I type in "sh boot" I get...

How do you get the Mac UAM volume to be created someplace other than the c: drive? Not much in the KB with answers. RG