Recent content by rmktech

Actually i swapped the one from the digital 30 to verify a working cable. thanks ron

did that. I have the red one from Avaya. thanks ron

manager 5.0 >upgrade does not show the module.!!! ron k

Hello, what's up with this? worked for a while now flashing green. Here is the scoop. ip 406v2 DS 5.0(20) analouge pots2 5.0.20 dig dcp 8 5.0.20 dig dcp x 30 57.0.20 analouge pots8 6.2.23 all was working fine. Suggestions????????? tried rebooting, check connections.. thanks ron k

thank you, I am going to try an avaya door phone without the light......... ip 406v2 rel 5.0x

Hello, I have a partner door phone (with light). Can/will this work with the ip office as a pots station?? setting's ?? Thanks Ron K

Hello all. I have a company that has a main office with 5 satalite locations. We have installed an IP Office at the main location and so far have upgraded two sat locations as of now. I would like to network them all together so they can share the same dial plan within the company.this may be...

Hello all. I have a customer that wishes to have add a second 6 port exp module. They are at MICS 7.1 now. I understand i have to convert them to 7.1 XC. I have been told conflicting procedures on how to perform upgrade. Would / could someone explain proper steps. Thank you. Ron k

Hello, i have a customer that has a 877 telephone number and they want to route inbound calls to certain area's depending on the area they originate in. Who offers this service?? thanks ron k.

Hello all, I have an IP Office 406v2 st up and running fine. I need to put a phone at a satalite location. I have a linksys rvs-4000 at each side with a vpn tunnel and shows the tunnel is up. I am not sure the IP Phone can see the system. here are the settings. main office IP-OFFICE...

Will the ip remote phone work with a dynamic ip?? Assumming i have 1 license and a netgear fvs338 vpn router?? Thanks Ron K.

thanks to all. Was able to *46 and get call. ron k

Is it possible to steal a call after vm picks up?? Calls come into group 300 after 4 rings goes to vm.. I would like to be able to intercept call, if poss?? thanks ron k

Hello, I have a customer that has an ip-office 406 at the main locations ans is going in with a ip-500 at one of the subsites. I need to link the two together. Both for 4 digit dialing back and forth and centralized vm. The subsite will have an ip on the same network as the main site. 4 vcm...

ASA or DSA Software.. I have a customer with this and there computer crashed, can 't find disk. Anyone know where I may get this from?? Thanks Ron k