My favorite solution is using a m0n0wall box which has a very nice captive portal. You can use any old PC (ie P3) to install m0n0wall, it will run off a live CD and use the floppy to save config info. They have a nice site with plenty of info. I would use a consumer grade A/P with dd-wrt...
You might want to connect a console cable to one of A/P's and see what messages roll by on the boot process. I usually like to connect the A/P on the bench before installing the unit. This will allow you to check the boot process and make sure the firmware upgrade is successful and there are no...
Thats ok, I was hoping to do the same thing. Take a look at the linux loads for some inexpensive A/P's. Some examples are dd-wrt or open-wrt. You will need to invest some time and effort but they appear to be getting close to a single box solution. I have several Cisco A/P's so I just set the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.