Recent content by rmack22138

Thank you AvayaTier3. This worked great. I looked everywhere to find this. The old guys like the terminal in the com room.

Hi lopes, I like having a terminal that is always ready to go and turned on.

Hi all, I have a 9.0 definity. My old SAT went and replaced with new. I however don't remember how to setup the F1 thru F8 keys. I know they have to be remapped but I don't know the SAT codes to assign? Could some one send me a list of SAT commands for the F keys? Thanks you

Hi all, I have an IPO 500v1 8.0 43. The original feature does not have any license features. I purchased a feature card with license features. How do I go about upgrading the new feature key card? Thanks in advance.

I did try this, but still doesn't work. When I manually dial the digits, it works. When the digits are dial automaticly or last number redialed, the call won't go through. I have a digit grabber verifying the digits sent.

Hi intrigant, I did try 3 commas, but still the same result. I have this set up on the user short code. Code 000XXX Telephone 268,,,N Feature Dial extn <-----also changed this to Dial Line Group 0 Could the short code be interfereing with dialing Code 268N Telephone N Feature Dial Line Group 9

Hi All, I have another question. I would like to have this Harris caller Id test to call back across a pri. The access number to the pri is 268. It does send all digits, but it needs a 1 or 2 second delay between 268 and XXXX. I tried to set this up several different ways but never works...

Hi Intrigant, I did get this to work. Thank you I had to add another X to code. 000XXXX

I did try this and still get the same thing. I put short code in the extension. Code 000XXX Telephone N Feature Dial exn Line Group 0

Hi All, I have a Harris Caller ID test unit connected to an analog port. The problem is, the test unit is dialing out 7 digits. The first 3 digits is always 000 and then the extension. Is there a way to delete the first 3 digits 000 and to just dial the last 4 digits in a short code?

HI all, Does anyone know of a place that sells power supplies for the IP 500 v1?

I tried the same setup with a slc 2000 remote terminal and couldn't get it to work.

I had a CMC go bad with a Tn2402 processor card and Avaya replaced the CMC with a G600. Its worked great and never had any problems. I thought maybe the G650 would get me a couple of extra card slots. Thanks you for the info.

Is it possible a TN2402&TN2182C work properly on a G650?

Does anyone have documents on slc 2000 BYB2 card setup? Thanks in advance