Recent content by riot6

Cisco IOS Software, 3800 Software (C3845-ADVENTERPRISEK9-M), Version 12.4(22)T2 ultilink1 is up, line protocol is up Hardware is multilink group interface Description: Internet address is xxx.xxx.xxx.xxx Encapsulation PPP, LCP Open, multilink Open Last input 00:00:00, output never, output...

Thanks DallasBPF. I will give that a shot. Might take awhile to get customer 'go-ahead' but I will post results when completed. Thanks again.

Multilink1 Bundle name: xxx.xxx.xxx.xxx Remote Endpoint Discriminator: [2] xxx.xxx.xxx.xxx Local Endpoint Discriminator: [1] Office Bundle up for 1w5d, total bandwidth 4608, load 2/255 Receive buffer limit 36096 bytes, frag timeout 1000 ms Interleaving enabled 0/0 fragments/bytes...

Has anyone seen this before? Can't get direct answer from Cisco. 2 serial interface are running error free (even tested to csu to verify). But seeing increasing input errors on the multilink interface. Thanks. Posted this in the past but wasn't able to resolve. MTR>sho int s0/1/0:2 | in...

Thanks for the update. I will give this and try and post results.

Hi, no, the physical interfaces never increment errors, even when pulled out of the multilink. Clocking - controller 0/1/0 set to line primary controller 0/1/1 set to internal (have tried multiple settings, no change....) Hardware - VWIC-2MFT-T1 (2) IOS - Version 12.4(15)...

Has anyone seen this before? Can't get direct answer from Cisco. 2 serial interface are running error free (even tested to csu to verify). But seeing increasing input errors on the multilink interface. Thanks. MTR>sho int s0/1/0:2 | in cou|CRC|carr|Des|Int CRC checking enabled Last...

Stifi, You can do this using DM or CLI - you must first know which port the MAC (device you want to copy packets) is located. DM - Click on VLAN -> VLANS -> select Id of the VLAN then click on Bridge -> FORWARDING. Find the MAC in the list and then under the MONITOR column, change from FALSE...

There is a way to get both ingress and egress traffic from a specific port but you have to filter on MAC address.

Same here. Thanks for the reply Rick.

Hi, does anyone know if there is a way to zero the counters, ( >sho sync/hssi stats ) from a Nortel router without booting the router? A MIB set or something? Thanks.

Anyone see this in their 8600 logs? We have seen this on a few of our PP's. running 3.5.2.0 HW ERROR portGetPortNum: invalid physical port 02b7 Thanks.

Hi Mankyway, Please send to rp139@dcx.com. Thanks.

Hi Mankyway, are you still available to send out copies of CLIManager? Thanks....

Hi, we are seeing this in a few of our routers and Nortel cannot tell us what these errors are referring to. The HSSI is a 12Meg FR circuit, no hits no runs no errors = clean. Running 14.0.3.1 version of code. MIB is: RTR***01>g wfHssiEntry.41 Thanks for any help anyone can provide....