Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by RickLopez2
-
SPAN configuration on 2950 switch
Tried setting source ports to ingress with same results. Decided to start over, erased switch config and setup only minimal configuration, then setup SPAN with same results. Here's a summary of the current config; show run Building configuration... Current configuration : 1622 bytes ! version...- RickLopez2
- Post #7
- Forum: Cisco
-
SPAN configuration on 2950 switch
I found an old Synoptics hub and plugged everything into that and started an Ethereal session and I can see all traffic on the hub which points me back to a problem with my Cisco configuration I assume. Thanks.- RickLopez2
- Post #4
- Forum: Cisco
-
SPAN configuration on 2950 switch
Thanks for the reply. I installed Ethereal on another PC as a test with the same results. If I turn off SPAN on port 24 the port then works normally. In looking at the interface in more detail I see; vlab-2950#show interfaces fastEthernet 0/24 status Port Name Status...- RickLopez2
- Post #3
- Forum: Cisco
-
SPAN configuration on 2950 switch
Hi, I am trying to configure SPAN on a 2950 switch for the first time but Ethereal doesn't capture any information other than spanning tree information. When I do a show monitor I get the following: vlab-2950#show monitor Session 1 --------- Source Ports: RX Only: None TX Only...- RickLopez2
- Thread
- Replies: 6
- Forum: Cisco
