Recent content by richardsdd

You system's specs will vary greatly depending on a number of factors. Such as: number of users, number of modules you plan to run, what OS/harware you want to run the system on, etc... To get the minimum technical requirements for the software, you will need to visit their website...

Another site is the JDElist. Good luck!

You can use the runube command line execute for a report.

Seeing as though performance issues vary from client to client, could you post a bit of their configuration?

cglass, What you are talking about sounds an a lot like a third party tool called AutoPrint. Which is made by Alex Pastuhov. You may want to talk to him about that product. It already has the functionality you are looking for.

Which version of WebSphere, JDE, etc...? Also, which settings have you changed in the JAS.INI? Dan

Hopefully you have a backup? If so, rebuild the server, reinstall JDE Deployment server, then restore your backup.

Here is the syntax: runube JDE JDE DV7333 R0006P XJDE0001 QB7333 Batch Print Save printer1 Good luck! Dan

Try deleting the user overrides for the user that receives this error.

Not true. There was an issue with SP18 through SP19.1 where the spec count for GBRSPEC wasn't matching on the client build even though the actual file was complete and ok. This caused the PDF to show that the build was not successful. This was fixed and if you are now on a SP20 or higher, you...

We've had issues similar to this in the past. For us it was either a bad package build or bad OCM mappings. Have you loaded any new SP or ESUs lately? Have you modified those BSFNs? Good luck!

When you use RUNUBE you can specify "Print" for print immediate and also you can specify which printer the job should go to. You can have your printer set up to forward to a remote queue on a different server for other output management functions. We are doing this today in Xe and ERP89 with a...

I'm pretty sure you still need to update the 98/JQ UDC to let the system know that QB7333 is a valid queue.

If you do, don't bother trying to mograte anything. Do a fresh install and config. You'll find it a lot easier in the end.

Do you have more than one entry in the default printer table for yourself? Are they both active? This shouldn't normally happen, but I've seen it happen.