Recent content by reverendo

I'am staring a monitor aplication, this link is usefull to me. Thanks Castor66 Regards

In IOS try: sh mac-address-table interface <Interface> In CAT-OS: sh cam dynamic <mod/port> Regards.

I don't used Big Brother, but are you seen opennms (www.opennms.org) this is a beauty tool (with a lot of features) to monitoring routers and switches with SNMP. Regards

See: http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800ca7b1.html for the first point you will need that both routers can reach the interface of antoher, the most simplest way is that both routers have public IP in its interface. But you can...

See multilink for cisco routers this can help you.

If you have configured destination network as part of crypto, you can send routing tables to peer with: in crypto map put: reverse-route remote-peer With this, when a VPN client connects to Cisco Router will get the routes needed via VPN tunnel.

I have a users with Outlook 2003 and they need to conect to Exchange 2000, this had worked fine some days ago, but we changed the Server behind a firewall and this users was unable to connect to exchange server, we have another users with Outlook 2000 and they can connect without problems. We...

had you try use Xon/Xoff in flow control setting?? Some times this works for HyperTerminal.

This status is diplayed on Cisco Routers when a G.703 interface is down due link problem (may be the interface is disconected) I think you have a interfaces that support a E1 or T1 with BNC connector and this links are down. In a V.35 or Ethernet interfaces you will see "down" when you have a...

In some tests over Cisco Router and Switch VPN3000 to make a VPN from a Client using Cisco VPN client with Certificate Authentication, we saw that both Cisco (router or VPN300) Fails when it try to get crl from webserver, all comunications are ok, cisco prompts a next messages: when a client...

Try using multilink interface, this is a group of your 2 WAN interfaces that works as one. You can see more details in cisco.com page, only search for PPP multilink Interface. Also you can make load-balancing with eigrp and other routing protocol, but you have take care that apply int f0/0 no...