Recent content by ReenaS

Background... 8720 Main Site (rls. 4) G350 Remote site (rls 4)--no 8300 in V0. I was wondering if someone knew the speed specifications for FoIP (t.38, fax relay mode) and a regular analog connection to a MM711 analog module? In addition does 4.0 support T.38 and how would this be...

Hi Folks, I have two CS1K switches trying to connect via SIP trunks. The issue that I run into is the end point does not stay registered. It registers and then un registers. Any suggestions. Both switches have updated patches, running transport TCP, and is using Dynamic SIP. Thanks in...

Hi folks, I am using program to access Meridian Mail, in order to use the "Find" function "F5" I need to edit F5 in my procom Keyboard editor. Does anyone know the string that will allow me to do this? Thanks!!

Correct! I am using PRI trunks. I need to inquire if our provider has DID set up. Thank you for this!

I am trying to publish DID numbers rather than the main telephone number. I have done the following and still no luck, it displays main number for all outbound calls ENTRY 0 HNTN 416 ESA_HLCL ESA_INHN NO ESA_APDN YES HLCL DIDN YES HLOC LSC CLASS_FMT DN I also ensured that...

Sorry, my question was how to I take the call back, if I notice that is it going to Voicemail? Thank you!!

Awesome!! That worked. You guys are just FABULOUS!!

Here's the thing though, when reception put a caller on hld, the incomming call (2ND CALL), does not indicate on lpk 2, or any key. It is impossible for them to grab the second incomming call. Am I missing something in my programming that allows this? Thanks again!!

Another console question, when receptions take a call on lpk 0 and stays on the line with the caller as she transfers them to their desired destination, how can she/he grab the caller back if they realize the call is going to V-MAIL. Again, she is on the line with the caller.

Options- #6 for Call waiting, 1- display -ON. It seems that my Call waiting indicator is on. Same problem.

Sorry to bother... but how would you do that?

That is normal. Once you record your ATT and call it again, you will hear the ATT rather than Silicon Sally!

Hi Folks, I have built a 2250 console with the below properties >ld 21 PT1000 REQ: prt TYPE: att TYPE ATT_DATA CUST 0 TYPE ATT_DATA CUST 00 OPT AHD BIND BIXA BLA DNI IC1 XTG IDP XLF XBL FKA MWUD LOD REA SYA ATDA ATDN 0 NCOS 6 CWUP YES CWCL 1 2 CWTM 6 12 CWBZ YES YES MATT NO RTIM...

You are correct. They are not prompted through the initialization phase.

Thank you very much for the advice. I will try this out!!