Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by redengineer

  1. redengineer

    Password tda 30

    NO - cannot find any docs for software upgrade?
  2. redengineer

    Password tda 30

    Cool - all done. I have downloaded newer version software from my distributors site - how do I upload? Looked in the book - cannot find???
  3. redengineer

    Password tda 30

    I have picked up a second hand TDA 30 but cannot access it via laptop due to it being password protected?? I have tried reset etc but must be doing somethng wrong?? Is there a procedure??
  4. redengineer

    UK based question

    Tried that but it would not stay in the slot, after hitting refresh. However the card was not in the system (through fear of it crashing it again!!). Therefore I deduce that card needs to be installed before telling the slot what card it is???????
  5. redengineer

    UK based question

    The manual links above go to TDA100 and te206 (ICS website)??!? I cannot find any literature on the svm - been looking today. I did power up a spare version 2 and saw that slot 9 would not take a SVM. Therefore (on the version 5 I have) do I need to click on slot, highlight the SVM, drag it...
  6. redengineer

    UK based question

    then i fliped through the -4 feature manual and user instructions for svm and recorded ogms for my needs and that set the fwd b/na codes for those ext's to suit my needs.... Cheers, but what do you meean by the -4 feature manual????
  7. redengineer

    UK based question

    Do you have any literature? Kinda late here and daughter is sleeping!!!
  8. redengineer

    UK based question

    Cool...I noticed that the SVM card appeared above slot 9 on the Slot menu..Do I need to drag this into slot 9? Will it then be "installed"?......and solve my problem. The SVM is to act as a simple voicemail for extensions with a DDI? I need to know how to get the SVM to kick in when a user is -...
  9. redengineer

    UK based question

    No, If you run the mouse over Slot 9, it tells you what card ca go there and SVM is one. I do not know if you can tell the slot what card is being installed - I thought that the system recognised what card had been installed. When I installed it and the problems began, I went onto the "slot"...
  10. redengineer

    UK based question

    Cheers, What do you mean by working only on -4's? The system is version 5 software. The floating ext number(s) are 591, 592? I think?
  11. redengineer

    UK based question

    Hi I tried to install a 2 channel simplified voice message card to a tda 15. I need to know - The TDA has 2 digit numbering, do I need to change it to 3? How do I set handsets to - go to voicemail if busy, go to voicemail if unanswered (how do I set amount of rings?) When plugging the card in...
See more

Part and Inventory Search

Back
Top