Recent content by rbtcom

Try the Delete Key instead of Backspace

He might need to use the Delete Key instead

The get the full benefit of the QSIG Signaling, you should upgrade to at least 25.40

The reason it has failed is because your station must be assigned to the XLST 1 on each station individual TN don’t restrict 7 to covert to “*” you must allow every number to pass as they are dialed on the Pre translation list for your stations. The consoles will be assigned to XLAT 0 and will...

If they are still dialing the access code you might have miss a step in the programming, because this will control what all the operators dial by putting them in a specific XLAT group thus controlling the keypad on the console and they should not be able to dial anything starting with the digit...

Looks good, But your stations can be restricted by TGARS instead of the PRE table SCL so you can allow 7 to be dialed for the XLAT 1. Since your only concern is the operator, or who ever is at the console, him or her will not be able to dial any number starting with 7. This is the only way...

Ok you have the Package, now what you need to do is build the translation group “0” (XLAT 0) and point it to a speed call list that you will create with entries 0 thru 9, it will look like this: SCL X STOR 00 0 STOR 01 1 STOR 02 2 STOR 03 3 STOR 04 4 STOR 05 5 STOR 06 6 STOR 07 * STOR 08 8...

Does your system have the Pretranslation PKG.??

Does you system have PRE-Transalation PKG??

rbtcom@bellsouth.net

Thank you daveyboy, now the question is who do I get the patch from Nortel? or Microsoft?

What rls of software are you running on?

It was loaded on two computers including the one in my office that has 256mb and I got the same results.

We have tried to load the CTA “Norstar Personal Productivity Suite 1.2 software on a W2K platform and the software starts to load and gets to a point that it just sits there at 50%, The Window Task Manager status indicates the application is at ”No Response” Is this CTA 1.2 software compatible...

I have a Norstar CIC system with 8 sets and erratically two of them go out of service and the “LED’s on the phones start to flash. The phones have been replaced and the wiring was checked but the problem persists. The phones however come back up into service by themselves with no intervention...