Recent content by rbanke

Also, With the dsl modem in routing mode, the cisco router will gain an ip from the modem. I can ping to the internet using the router however, clients cannot.

This is a sh run and sh int with the dsl modem in bridge mode. I can plug the dsl modem into my laptop and recieve the public ip, however as you can see the ethernet interface does not. I checked on the modem and there does not seem to be a way to force 10/half. sh run Building configuration...

Plshlbme, the public ip of the dsl modem is not static. If i remember correctly, when the dsl modem is in bridge mode it should pass the public ip to whatever is connected to the dsl modem ethernet port, right? While the dsl modem was in bridging mode, I could connect a laptop to its ethernet...

Thanks for the reply Burt! Yes it is DSL. One of the configurations I did try was to leave the modem setup as it came which was routing mode, nat enabled, dhcp enabled. When I set the router's wic to dhcp it DID gain an ip from the DSL modem however when I set my default route to point to the...

Hello, It's been a long time since I had to do any work on routers and for some reason I cant get this working (memory/old age, or both) so I am appealing to some good natured souls for some help ;) I have a 1720 with an 1ENET WIC which i would like to connect a zyxel 660 DSL modem to as the...

In the process of adding a 1ENET WIC to a 1720 and have just found that this is unsupported in the ios version currently on this router (12.1). The router's flash and mem had been upgraded in the past so it seemed simple to just get a newer ios for it. However, the smartnet contract has lapsed...