Recent content by Raymondo206

The array manager should let you rebuild the disk. It may have just had a glitch. We have had that here a few times. If you choose to replace the disk you will still have to get the array manager to rebuild the drive. That is if you do not have a hot swap disk, whick with 4 drives i dont...

Do the servers have a second power Supply? The orange light could be complaining about the second power not being plugged in.

Don't want sparks and smoke.. Just loads of led's like WOPR in War games.. ;)

Hi all Bit of a strange request here.. Does anyone know where I can order some 'fake' computer lighting for a server rack system. You know the sort of lighting you see in movies (lots of twinkling LED's etc). Just want to freak out the occasional visitor to out Server room. Cheers Ray

I would have a look at IPFX.com We Currently run a system called Altitude. we are moving over to IPFX. IPFX has much more funtionallity/stability. Ray

Hello Does anyone know of a tool that will allow me to shrink a Netware 6.5 datapool? I am trying to use Portlock to image a server to a new box, however the pool on the old server is smaller than the new box. Apparently Server Magic 6.5 for Netware would allow this however Symantec purchased...

What sort of problems were you getting pndscm?

Have you any experience with the Spectralink stuff Eyeteaguy? The i640 looks like what we need. Any experience integrating with callmanger?? Cheers

We currently run around 50 Cisco 7920's in a manufacturing environment. We believe that these phones are not very suitable for our type of factory (very dusty / noisey). Can you connect any other Wireless VIOP handset into the call manager. Our access points are Cisco Airnet 1200's. Any...

The 7920's seem to work really well. We are currently running two sites with about 45 handsets and about 40 AP's. (the sites are very big!) There are a few niggles, the ring tones being one of them. A shared address book has also been requested a number of times. We have only just upgraded to...

Yes we have just updated the FirmWare to 1.08. We are using the outdoor profile. The only loud ringtones we have is Loud Laser Loud Classic ring 1 Loud Analogue Synth 1 Loud Chirp 1 Loud Chirp 2 Are there supposed to be more? Cheers

We are currently runing a number of 7920's in a factory environment. We are using the Cisco 'Loud' ringtones, volume set to max, and set to vibrate. These however are still a bit quiet. Does anyone know of any really loud ringtones for the 7920. Cheers Ray

Yes thanks would be very interested. If you could send me the info it would be great. Thanks Ray

Thanks for the advice fella's. So in a nutshell I will have to modify the Gateway to allow this to happen? Ray

Simon Just out of interest do you use any monitoring software on you AP's? Have been looking at a couple of SMNP tools but not decided on one yet. Regards Ray