Ok so I just got done installing a new server with no problems. I got most of it dialed in nice then I got to a point where I had to re-boot the machine after re-booting the system went to 640*480 resolution the network card had to be re-installed and ALL the setting I put in were lost. This...
Alright we fixed it!!!!!
Problem: Trying to install W2K Server it would start the basic set up files then when it came time to reboot it would not pick up where it left off. Instead it started the basic install again ERROR MESSAGE: "Couldn't open boot partion to inspect for...
I'm booting directly from CD no other O/S is on the drive ALTHOUGH XP has said it has found another O/S would u like to overite it? which I dont get because I just formated the drive twice. (7GB drive partioned as C:) 8mb unpartioned space? maybe its the cd-Rom not picking up where it left...
My Bios has no virus checking capabilities. By the way thanks for the help folks I do appreciate it.
Error Message Qick flash on screen: "Couldn't open boot partion to inspect for signature"
Then the install starts all over again.
I did format the drive numerous times. I also reset the Bios to see if this helped. And I tried 2 other hard drives no luck same problem.
Problem: After the initial set-up XP reboots itself (Like its suppose to) then instead of picking up and continuing the install it starts the install all...
Ok here is my problem Iv'e been trying to install XP pro on the PC. XP reads the disk and installs the basic drivers then reboots then a quick message flashes on the screen "Couldn't open boot partion to inspect for signature" there are no partions just a NTFS C: drive.
and instead...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.