Recent content by Rapetou

Thanks XZombi, I will try it next monday... I will post the result after. Thanks again. Rapetou

F819 is working if your using OLI in your system. I can not use OLI with analog trunks so, it doesn't work.

Hello all, I know we can use "*67" with Bell Canada to hide your CLI on outgoing calls. What is the * code we can use on Centrex lines? The "*67" is note working on it Thanks Rap.

My BCM is back!!!!! Here is a new star for MRMARSHALL Thanks Rapetou

Hey !!! Thanks Mrmarshall... I will try your procedure. I hope I'll be back qith a STAR for you.... Regards Rapetou

Hi! We have tried to restore a Edge 1000 with a BCM 200 Backup. The version 3.6 was on these two BCM's. Now the Edge 1000 don't start. We have put the Ghost of the HD we have taked before and we get the same result. Maybe the MSC cards are corrupted... Any ideas????

Can I disable a port on CallPilot 100? We can connect only 1 port to the CICS (only 1 port available). Sometimes the CallPilot freeze and stop to answer any external or internal call and no more available from network on Ethernet port. Can it be caused by the port #2 ???? Let me know...

Yes you can. Just create a mailbox for the attendant of this group and set Call forward no answer to the number of ring you want and the call will be answered by this mailbox... and if you want you can assign a different DN attendant for this mailbox if the customer dial zero at the message...

you can had your card in the Trunk module in slot 1 only an you will get it in your config... Good luck

We can have a dial tone with MICS version 6.1 but can we have it in BCM 3.6 ??? When i dial 9 to access the trunk group, i don't have any tone.... I was thinking we will get it with the new 3.6... Some news about it? Rapetou

You have to connect your Valcom on an Analog Trunk port. You can't dial any digits by the paging port from any Nortel system. Good Luck!

Where can i find the nvm2ppp.inf driver to access NVM 4.0 ???

To use Norstar manager on XP you will need the 3.7 version.

I have buy a new notebook this week. I have installed Win XP PRO first on a partition and i'm tryng to install RedHat 9 on the second one. When I boot from the CD, I start the install in Graph or text mode and i get the same problem. I get a blank screen after some seconds and HD and CD stop...

i still have the same problem ... When i connect direct to the modem i have no problem But sending email with a linux is ok. I only have problem with Outlook with BEFSR11 (i have made 3 cold start and Default settings)