Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Randini

  1. Randini

    Adding 308 blows fuse, ? about card order (5 slot ACS)

    LOL, What fun this is!!! I will get back with episode II: Revenge of Randy. (Since I am working with a production system, I am playing it out by ear. Sorry, no timeline yet.)
  2. Randini

    Adding 308 blows fuse, ? about card order (5 slot ACS)

    Well, I plugged the 308 into the wall and *poof*. I hate/love the smell of blown fuses. So I took a look at the power supply to see what and where. 1. The fuse was blown 2. The "big black pancake" circuit (the one with the c90-11 on it) was wacked out. (It looked like it arched with the...
  3. Randini

    Adding 308 blows fuse, ? about card order (5 slot ACS)

    Thanks for the advice Chris and Paul. (Same names as my brother and father, heh) I will use the spare power cord I have and plug in the 308 directly without being in the carrier. I didn't dare try that without "consent". About putting it in slot 1, cool thanks. -Randy
  4. Randini

    Adding 308 blows fuse, ? about card order (5 slot ACS)

    Hey Paul, Never safe to assume... Yes I did power down the carrier =) Yeah, the VS is in the last slot (slot5), so that's cool. Thanks for the help. Randy
  5. Randini

    Adding 308 blows fuse, ? about card order (5 slot ACS)

    I want to add a 308EC to my working system. What would be the proper order to place my cards in? I have the following working configuration: +-------------------- |VS R5.0 [slot 5] +-------------------- |200E R3.1 [slot 4] +-------------------- |ACS R5.0 [slot 3] +--------------------...
  6. Randini

    Forward a messave without comment. Possible?

    I have Partner VS 5.0, forgot to mention.
  7. Randini

    Forward a messave without comment. Possible?

    Is is possible to forward a message with recording a comment?. Does any one have a work around if it is not possible? Thanks, -Randy
  8. Randini

    Swapping power supplies work? ( 308EC with 206 )

    Chris I got a new thermistor, diode, and fuse, so I may try repairing the power supply just for kicks, but before going through I was curious about the swap. Aarenot You are correct, in that some of the compenents are different. This leads me to try the repair first. Skip555 I don't want to...
  9. Randini

    Swapping power supplies work? ( 308EC with 206 )

    I have a 308EC with a bad power supply. I won't go into detail as how it went bad, because you guys would think I was a total dweeb. I have a 206 (and 206E) with a good power supply. Can I swap the power supplies? They seem to have the same grey plug, the same green ground wire, and the same...
  10. Randini

    Partner VS 5.0 led flickers when processing, normal?

    Hello again, I notice the following activity when the Partner VS 5.0 module is being used or has current load: Is this normal? (I'm a little trigger shy as you can see) 1) Led Flicker (similar to a PC hard disk led) 2) Hard Disk access noise (somewhat obnoxious) Note: The Led flicker is...
  11. Randini

    Partner VS 5.0 Led goes off after initial boot up...

    telprog itpphoneguy, rock on!!! Thanks so much! It works wonderfully! hbiss, thanks for the info, but slot 1 did it for me.
  12. Randini

    Partner VS 5.0 Led goes off after initial boot up...

    When I turn on my system, the Partner VS module light goes red for half a second, then goes solid green for about 2-3 seconds, and then the led turns off. I do however continue to hear the hard drive making some noise, spinning, reading, or whatever it may be doing. The ACS stays solid green...

Part and Inventory Search

Back
Top