Recent content by ramavi

Thats what I was looking for. Thanks Googer & PederChr.

So there isnt an area specifically labeled "Default route", correct? Do I make the static route to my wan routers ip?

How can I setup a default route on an ARN. I can access via Site Manager but cant seem to find where this option is. The router has two ethernet ports, one "public" and one "private". I need to point this router to an existing WAN router on the public side. Help.

would 100 54mb wireless connections be ok over a 100mb ethernet backbone?

Can anyone tell me if there is a limitation or general guideline as to the number of users connecting to a access point? The back bone is 100Mb ethernet. I'm thinking of requesting the D-Link DWl-7100AP for a new office area.

My ML570 comes up with the warnings; "A processor power module has failed (slot 9, socket 2/3). the system will continue to operate" and immediately thereafter, "The Compaq system manager driver has detected that the processor power sub-system is no longer redundant&quot...

yes, 87 & 27 are CDP'd as a DSC to another pbx via tie lines. the problem is I have over 300 people that use 8770 to access their voicemail (in another pbx). Due to time and other constraints, I'm not able to tell everyone to start dialing 2770 before 8770 goes inactive. So I'm wanting to tell...

Help. I need to modify my system so that when someone dials 8770 (external extension)the system will actually outpulse 2770 (external extension as well). They both leave via the same tie lines.

Here you are avilar@tce.com

Yes the board is enable (i even toggled it off then on again). the ports are all setup as dte 9600. The cable im using however is a standard db9 to 25 cable. Where can I get the correct pin out?

I tried and still no comms. Not even garbage which i would expect if i had one of the settings wrong (baud, parity, etc). I even configured a new tty port (4) with just sch but got nothing.

I'm trying to setup a cdr port on my 61c nt8d41ba card and cant seem to get any communication out of the ports. I believe i've covered everthing on lds 15 & 17. I've followed the steps off of Russells web page but no dice. Help. How can I insure the card/ports are ok?

I've been asked to locate an inexpensive (2k-3k) voicemail system for an option 11 system (about 6 ports for 80 users). I would imagine that the meridian mail and call pilot would be out due to cost. Any other brands that I can invesigate?

We have been experiencing some pretty messed up messages when retreived from our Audix voicemail system. The problem occurs when people leave a message both internally and externally. Its been suggested that the drive might be close to capacity but I'm thinking it may be the audio path on one...

Thanks for the info. Apparently our system is not setup for the remote access option. The money people don't want to spend any to get it added. Oh well.