Recent content by Psingh

Hi, Give the following command at the command prompt and get the output: net user > userlist.txt PSingh

Hi, Just see if you had chosen the option to show ALL Members in the server manager. PSingh

Hi, Install the new server as BDC. Then Switch of ur current older PDC. Go to server manager in BDC and promote it to PDC. After succesfull promotion bring up the older PDC. Go to the server manager in older PDC and demote it to BDC. Hope this can do the work. I had done in the same way. PSingh

Hi All, I had faced the same problem earlier of getting tons of mails in IMC queue and IMC not getting started after rebotting the server but now I had got it fixed. Solution in my case is : During installtion of WinNT for our Exchange Server we had left the loacl admin password blank. After...

Hi, Select the tasks that you want to send and then right click. Then select "Forward" and then send the mail

Hi, Remove that check mark that u had placed for " Relay mail if localy connected" and place a check mark in front of the next option "Relay mail only if received from these IP Address" without enterning any ip address in the below given box. Restart the IMC and then check...

Hi, For this u need to have a third party software for fetching the mails from ur ISP. PSingh

Hi, In Exchange Server, open the properties if Internet Mail Service. On the Connections Tab there is a feature called "Message Filtering". Open that and add the email address or the domain name that u want to block. Apply the changes. U have to stop and restart the Internet Mail...

my apologies, I read Gilroy's post wrong. PSingh

Matt, I thing u should read the reply completely before attempting to comment, its good for ur health and i don't want to comment on ur knowledge and level of understanding PSingh

Hi Gilroy, I think there is no need to add a PCI card. Only u have to change the Ribbon cable that is attached to ur 20Gig HDD rightnow. Change the cable from two connectors to three connectors, where two are for two Hard Drives and one is to connect the drives to the system board. PSingh

Have u tried recreating the user profile. PSingh

Hi, Check under WWW service, for blockage of microsoft.com site. PSingh

Hi, Delete and recreate the user profile and on that particular machine, on which u r faccing the problem, give the user administrative rights and then see. PSingh

I think the DNS server is unable to resolve the domain name. Try tracing the route of that particular domain name or try nslookup. PSingh