Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by prince78

  1. prince78

    Avaya IPO remote hunt groups

    Tom Thanks for your input. I think this forum is much better than Catalyst support. I also checked my remote end and see 5 VCM channels as well. Dont I need VCM cards along with VCM channels? When we bought the unit we got some licenses which included VCM channel license. I dont see any...
  2. prince78

    Avaya IPO remote hunt groups

    1mS PRN: Monitor Started IP=10.10.10.113 IP 406 DS 5.0(15) Canton406v2 1mS PRN: LAW=U PRI=0, BRI=0, ALOG=8, ADSL=0 VCOMP=5, MDM=0, WAN=0, MODU=1 LANM=0 CkSRC=0 VMAIL=1(VER=2 TYP=1) CALLS=2(TOT=4249) 327mS RES: Tue 13/4/2010 10:23:11 FreeMem=37777552(2) CMMsg=6 (8) Buff=100 595 500...
  3. prince78

    Avaya IPO remote hunt groups

    I was wondering how was that working in 3.2(67) without the VCM card? Do you think it wouldnt have worked?
  4. prince78

    Avaya IPO remote hunt groups

    Bas1234 - Yes I did ticked Advertise huntgroups tlpeter - Yes I see IP Office SCN and selected that as well. I did some reading on this and will I need VCM cards and any additional licensing for thsi to work?
  5. prince78

    Avaya IPO remote hunt groups

    I created the VPN between the locations and can dial the extensions of remote location however I do not see the remote huntgroups on my system. I do see Redistribute hunt groups option on the IPOs. When I check the IP Line config, I do not see Voice Networking option in 5.0(15). This option was...
  6. prince78

    Avaya IPO remote hunt groups

    Hi I have an Avaya IP406 at my end and another Avaya IP406 at remote office. Both are upgraded to 5.0(15). I have a requirement that when a call comes in it should ring on the local and remote hunt groups. Hunt groups are configured at both ends. I would like to know how can I get this...
  7. prince78

    Request urgent help --> ASA to PIX VPN setup

    As I found the hardware is not supporting ip unnummbered, I have changed the configs as below ASA route outside 0.0.0.0 0.0.0.0 210.55.6.50 icmp permit any echo inside icmp permit any echo outside icmp permit any echo-reply inside icmp permit any echo-reply outside icmp permit any...
  8. prince78

    site-to-site VPN issue

    I have my config pasted on the link below. Can you please check this and advise. This is really urgent to me. http://www.tek-tips.com/viewthread.cfm?qid=1312952&page=2 Appreciate any advise. thanks
  9. prince78

    site-to-site VPN issue

    hi thanks for the reply. I am trying to access internet from the local site and seems that it doesnt pass through the firewall. though I dont have acls from inside to outside, there is something stopping me to access the internet from local network. By the way, I have already used the command...
  10. prince78

    Permit and deny services

    hi This is a nice thread. Just want to relate my problem with this thread. Today I had a problem while setting up VPN from site-to-site. I have acls to allow all local traffic to remote network via the vpn as interesting traffic through crypto map without natting. I have all other traffic going...
  11. prince78

    site-to-site VPN issue

    Hi I have configured a site-to-site IPSEC VPN and seems like I have some basic issues. Can you please advise? can ping from LAN to ASA inside interface cannot ping from LAN to ASA outside interface can ping from ASA to internet (eg:cisco.com) can ping from router to internet (router is...
  12. prince78

    PIX/ASA VPN spoke-to-spoke NEED HELP ASAP!!

    mingtmak, I have attached my configs and setup on the thread below. Can you please check the configs and advise me further. http://www.tek-tips.com/viewthread.cfm?qid=1312952&page=1 thank you
  13. prince78

    Request urgent help --> ASA to PIX VPN setup

    Hi I am working on VPNs for the first time and I have the setup and config as below. Can someone please check these configs and advise if any changes required. Local network remote network switch - ASA - 1700 router - internet(T1) - ISProuter - pix - switch A...
  14. prince78

    ASA vpn to pix

    Hi, thanks for that. What about the traffic coming from internet accessing internal servers, should I do the natting on the router or on ASA? My requirement is anything coming from internet to wan interface on router (e1-3.3.3.1) should be natted to ASA outside interface (2.2.2.1) and...
  15. prince78

    PIX/ASA VPN spoke-to-spoke NEED HELP ASAP!!

    mingtmak, I believe you have a router after the ASA connecting into the internet right? If so, does it have the basic config and allowing all traffic coming from the firewall?
See more

Part and Inventory Search

Back
Top